Conf
idential
SERVICE MANUAL
PERSONAL COMPUTER
Design and specifications are subject to
change without notice.
PCG-K23/K23F/K23Q/K25/K25F/K27
PCG-K215M/K215S/K215Z
Ver. 6 2005F
Revision History
S400
9-876-373-06
Area
Model
Lineup
PCG-K23
PCG-K25
PCG-K27
PCG-K23F
PCG-K25F
Quebec
PCG-K23Q
PCG-K215M
PCG-K215S
PCG-K215Z
AEP/UK
European
American
US Canadian
Latin
1 [MA]
1 [MA]
1 [MA]
-- 2 --
Confidential
PCG-K23/K23F/K23Q/K25/K25F/K27 (AM)
PCG-K215M/K215S/K215Z (EU)
Information in this document is subject to
change without notice.
Sony, VAIO and CLIE are trademarks or regis-
tered trademarks of Sony. Microsoft, Windows,
Windows Media, Outlook, Bookshelf and other
Microsoft products are trademarks or registered
trademarks of Microsoft Corporation in the
United States and other countries. The word
Bluetooth and the Bluetooth logo are trademarks
of Bluetooth SIG, Inc. AMD, AMD logo, AMD
Duron and combinations there of, 3DNow!, are
trademarks of Advanced Micro Devices, Inc. Intel
Inside logo, Pentium and Celeron are trademarks
or registered trademarks of Intel Corporation.
Transmeta, the Transmeta logo, Crusoe Processor,
the Crusoe logo and combinations there of are
trademarks of Transmeta Corporation in the USA
and other countries. Graffiti, HotSync, Palm-
Modem, and Palm OS are registered trademarks,
and the Hotsync logo and Palm are trademarks of
Palm, Inc. or its subsidiaries. (M) and Motrola are
trademarks of Motrora, Inc. Other Motrola prod-
ucts and services with (R) mark like Dragomball
are the trademarks of Motrola, Inc.
All other names of systems, products and services
in this manual are trademarks or registered trade-
marks of their respective owners. In this manual,
the (TM) or (R) mark are not specified.
Caution Markings for Lithium/Ion Battery - The
following or similar texts shall be provided on
battery pack of equipment or in both the operating
and the service instructions.
CAUTION: Danger of explosion if battery is
incorrectly replaced. Replace only with the same
or equivalent type recommended by the manu-
facturer. Discard used batteries according to the
manufacturer's instructions.
CAUTION: The battery pack used in this device
may present a fire or chemical burn hazard if mis-
treated. Do not disassemble, heat above 100°C
(212°F) or incinerate. Dispose of used battery
promptly. Keep away from children.
CAUTION: Changing the back up battery.
· Overcharging, short circuiting, reverse charg-
ing, multilati on or incineration of the cells
must be avoided to prevent one or more of the
following occurrences; release of toxic materi-
als, release of hydrogen and/or oxygen gas, rise
in surface temperature.
· If a cell has leaked or vented, it should be
replaced immediately while avoiding to touch
it without any protection.
Service and Inspection Precautions
1. Obey precautionary markings and
instructions
Labels and stamps on the cabinet, chassis, and
components identify are as requiring special
precautions. Be sure to observe these precautions,
as well as all precautions listed in the operating
manual and other associated documents.
2. Use designated parts only
The set's components possess important safety
characteristics, such as noncombustibility and
the ability to tolerate large voltages. Be sure that
replacement parts possess the same safety charac-
teristics as the originals. Also remember that the
mark, which appears in circuit diagrams and
parts lists, denotes components that have particu-
larly important safety functions; be extra sure to
use only the designated components.
3. Always follow the original design
when mounting parts and routing
wires
The original layout includes various safety fea-
tures, such as inclusion of insulating materials
(tubes and tape) and the mounting of parts above
the printer board. In addition, internal wiring has
been routed and clamped so as to keep it away
from hot or high-voltage parts. When mounting
parts or routing wires, therefore, be sure to du-
plicate the original layout.
4. Inspect after completing service
After servicing, inspect to make sure that all
screws, components, and wiring have been
returned to their original condition. Also check
the area around the repair location to ensure that
repair work has caused no damage, and confirm
safety.
5. When replacing chip components...
Never reuse components. Also remember that
the negative side of tantalum capacitors is easily
damaged by heat.
6. When handling flexible print
boards...
· The temperature of the soldering-iron tip
should be about 270°C.
· Do not apply the tip more than three times to
the same pattern.
· Handle patterns with care; never apply force.
Caution: Remember that hard disk drives are
easily damaged by vibration. Always handle
with care.
-- 3 --
Confidential
PCG-K23/K23F/K23Q/K25/K25F/K27 (AM)
PCG-K215M/K215S/K215Z (EU)
TABLE OF CONTENTS
Section
Title
Page
CHAPTER 1. SPECIFICATIONS
1-1. Specifications ...........................................................................................................................1-1
(to 1-1)
CHAPTER 2. BLOCK DIAGRAM ......................................................................................2-1
(to 2-1)
CHAPTER 3. FRAME HARNESS DIAGRAM ...............................................................3-1
(to 3-1)
CHAPTER 4. EXPLODED VIEWS AND PARTS LIST
Palmrest
P-1 ............................................................................................................................................4-2
Main Board
M-1 ...........................................................................................................................................4-4
Bottom
B-1............................................................................................................................................4-6
Hood Keyboard
H-1............................................................................................................................................4-8
LCD
L-1. 15.4-inch WXGA (High Brightness) Made by QDI...................................................4-10
L-2. 15.4-inch WXGA (High Brightness) Made by AU ....................................................4-12
Accessories
A-1..........................................................................................................................................4-14
DIP Switch ......................................................................................................................................4-15
(to 4-15)
CHAPTER 5. OTHERS
5-1. The Barcode Label ...................................................................................................................5-1
5-2. Replacing the CPU ...................................................................................................................5-2
(to 5-2)
Section
Title
Page
History of the changes is shown as the "Revision
History" at the end of this data.
2 [ADD]
Confidential
PCG-K23/K23F/K23Q/K25/K25F/K27 (AM)
PCG-K215M/K215S/K215Z (EU)
1-1
(END)
CHAPTER 1.
SPECIFICATIONS
1-1. Specifications
The trademarks of registered trademarks of above table, refer to page 2.
PCG-K27
PCG-K25
PCG-K23
PCG-K23Q
PCG-K25F
PCG-K23F
CPU
MobileP4-3.06GHz
P4-2.8GHz
P4-2.8GHz
P4-2.8GHz
P4-2.8GHz
Cel-2.8GHz
Graphic
RADEON IGP
345M
RADEON IGP
345M
RADEON IGP
345M
RADEON IGP
345M
RADEON IGP
345M
RADEON IGP
345M
LCD
15.4"WXGA
(Hight Brightness)
15.4"WXGA
(Hight Brightness)
15.4"WXGA
(Hight Brightness)
15.4"WXGA
(Hight Brightness)
15.4"WXGA
(Hight Brightness)
15.4"WXGA
(Hight Brightness)
HDD
80GB60GB60GB60GB40GB40GB
OPT-DRIVE
DVD+/-RW
DVD+/-RW
CD-RW/DVD-ROM CD-RW/DVD-ROM
DVD+/-RW
CD-RW/DVD-ROM
MEMORY
256MB x2
256MB x2
256MB x2
256MB x2
256MB x2
256MB x 2
QUANTITY
[MAX]
1GB
1GB
1GB
1GB
1GB
1GB
AC adaptor
PCGA-AC19V9
PCGA-AC19V6
PCGA-AC19V6
PCGA-AC19V7
PCGA-AC19V7
PCGA-AC19V7
Battery
PCGA-BP2NY
PCGA-BP2NY
PCGA-BP2NY
PCGA-BP2NY
PCGA-BP2NY
PCGA-BP2NY
internal W-LAN
OS
WinXP Home
WinXP Home
WinXP Home
WinXP Home
WinXP Home
WinXP Home
PCG-K215Z
PCG-K215S
PCG-K215M
CPU
MobileP4-3.06GHz
P4-2.8GHz
P4-2.8GHz
Graphic
RADEON
9200(64MB)
RADEON
9200(64MB)
RADEON IGP
345M
LCD
15.4"WXGA
(Hight Brightness)
15.4"WXGA
(Hight Brightness)
15.4"WXGA
(Hight Brightness)
HDD
60GB
60GB
40GB
OPT-DRIVE
DVD+/-RW
DVD+/-RW
DVD+/-RW
MEMORY
256MB x 2
256MB x 2
256MB x 2
QUANTITY
[MAX]
1GB
1GB
1GB
AC adaptor
PCGA-AC19V9
PCGA-AC19V6
PCGA-AC19V6
Battery
PCGA-BP2NY
PCGA-BP2NY
PCGA-BP2NY
internal W-LAN
OS
WinXP Home
WinXP Home
WinXP Home
EU
AM
1 [MA]
1 [MA]
1 [MA]
Confidential
PCG-K23/K23F/K23Q/K25/K25F/K27 (AM)
PCG-K215M/K215S/K215Z (EU)
2-1
(END)
CHAPTER 2.
BLOCK DIAGRAM
ALI 1535+
South Bridge
DC JACK
AC LINK2
AC LINK1
USB 2.0
K/B LED
T/P SWITCH
RJ11
TPA0312
XBUS
BIOS
TOUCH
PAD
EXT.MIC.
POWER SWITCH
EXT.SPKR.
MDC
ALC203
LPT
INT.K/B
NS PC87570
INT.SPKR.
Bettery LED
PCU
Power LED
T/P BOARD
PRIMARY
IDE
BUS
HDD
CDROM
S
ECONDARY
IDE
BUS
478 PIN mPGA
NORTH BRIDGE
System bus
400/533MHz
Intel
Pentium 4 75W
SO-DIMM 1/2
DRAM SIGNAL
DDR 266
DDR CLOCK
MAIN POWER BOARD
BATTERY
NEC
UPD720101
Power SW BOARD
RTC
TIBQ3285LF
RTL8100BL
RJ45
Memory
Stick
1394
TI-PCI7420
SLOT0
CRT
LCD
AVOUT
R/G/B
LVDS SIGNAL
TV SIGNAL
USB*3
Realtek
AGP bus
PCI bus
ATI RS200MP
DDR VRAM
16MBX4
ATI
RADEON 9200
(M9+X)
Wirless LAN
Mini PCI
(SN0307009GHK)
PWS-41
SWX-169
SWX-168
IFX-169
Memory
stick
BOARD