AUDIO/VIDEO
MULTI-CHANNEL RECEIVER
VSX-11
TV CONTROL
PERSONAL
SURROUND
DSP MODE
PRO LOGIC
5-D THEATER
VIRTUAL
5.1CH
TEST TONE
CENTER
REAR.L
REAR.R
MULTI
OPERATION
COMMANDER
SET UP
TV/VCR
DVD
LD/SAT
CD
VCR
TUNER
FUNCTION
MODE CHECK
SYSTEM OFF
DISC
+10
0
9
8
7
6
5
4
3
2
1
CHANNEL
MULTI CONTROL
D
Î
MULTI CONTROL COMMANDER
PRE-PROGRAMMED AND LEARNING
RECEIVER
TV
FQ
FQ
TV F
UNC
VOL
VOL
ENTER
MUTIN
G
Operating
Instructions
2
<ARB7135>
WARNING: TO PREVENT FIRE OR SHOCK HAZARD, DO
NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.
Thank you for buying this Pioneer product.
Please read through these operating instructions so you
will know how to operate your model properly. After you
have finished reading the instructions, put them away in
a safe place for future reference.
In some countries or regions, the shape of the power plug
and power outlet may sometimes differ from that shown
in the explanatory drawings. However the method of con-
necting and operating the unit is the same.
IMPORTANT NOTICE
The serial number for this equipment is located on
the rear panel. Please write this serial number on
your enclosed warranty card and keep it in a secure
area. This is for your security.
THE POWER SWITCH IS SECONDARY CONNECTED
AND THEREFORE DOES NOT SEPARATE THE UNIT
FROM MAINS POWER IN STANDBY POSITION.
The words "TRUSURROUND", "SRS", "Sound Retrieval System" and SRS sym-
bol
are trademarks of SRS Labs, Inc. Made under license from SRS Labs,
Inc. Patented in the USA and selected countries. Purchase of this product does not
convey the right to sell recordings made with the Sound Retrieval System.
The exclamation point within an equilateral
triangle is intended to alert the user to the presence
of important operating and maintenance
(servicing) instructions in the literature
accompanying the appliance.
IMPORTANT
The lightning flash with arrowhead symbol, within
an equilateral triangle, is intended to alert the
user to the presence of uninsulated "dangerous
voltage" within the product's enclosure that may
be of sufficient magnitude to constitute a risk of
electric shock to persons.
CAUTION:
TO PREVENT THE RISK OF ELECTRIC SHOCK, DO
NOT REMOVE COVER (OR BACK). NO USER-SER-
VICEABLE PARTS INSIDE. REFER SERVICING TO
QUALIFIED SERVICE PERSONNEL.
RISK OF ELECTRIC SHOCK
DO NOT OPEN
CAUTION
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15
of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not in-
stalled and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
Manufactured under license from the Dolby Laboratories Licensing Corporation.
DOLBY, the double-D symbol
and "PRO LOGIC" are trademarks of Dolby
Laboratories Licensing Corporation.
This Class B digital apparatus meets all requirements of the Canadian Interference-Causing Equipment Regulations.
Cet appareil numérique de la Classe B respecte toutes les exigences du Règlement sur le matériel brouilleur du Canada.
3
<ARB7135>
READ INSTRUCTIONS -- All the safety and operating
instructions should be read before the product is
operated.
RETAIN INSTRUCTIONS -- The safety and operating
instructions should be retained for future reference.
HEED WARNINGS -- All warnings on the product and
in the operating instructions should be adhered to.
FOLLOW INSTRUCTIONS -- All operating and use
instructions should be followed.
CLEANING -- Unplug this product from the wall outlet
before cleaning. The product should be cleaned only
with a polishing cloth or a soft dry cloth. Never clean
with furniture wax, benzine, insecticides or other
volatile liquids since they may corrode the cabinet.
ATTACHMENTS -- Do not use attachments not
recommended by the product manufacturer as they
may cause hazards.
WATER AND MOISTURE -- Do not use this product
near water -- for example, near a bathtub, wash
bowl, kitchen sink, or laundry tub; in a wet basement;
or near a swimming pool; and the like.
ACCESSORIES -- Do not place this product on an
unstable cart, stand, tripod, bracket, or table. The
product may fall, causing serious injury to a child or
adult, and serious damage to the product. Use only
with a cart, stand, tripod, bracket, or table
recommended by the manufacturer, or sold with
the product. Any mounting of the product should
follow the manufacturer's instructions, and should
use a mounting accessory recommended by the
manufacturer.
CART -- A product and cart combination should be
moved with care. Quick stops, excessive force, and
uneven surfaces may cause the product and cart
combination to overturn.
GROUNDING OR POLARIZATION
¶ If this product is equipped with a polarized alternating
current line plug (a plug having one blade wider than
the other), it will fit into the outlet only one way. This
is a safety feature. If you are unable to insert the plug
fully into the outlet, try reversing the plug. If the plug
should still fail to fit, contact your electrician to
replace your obsolete outlet. Do not defeat the
safety purpose of the polarized plug.
¶ If this product is equipped with a three-wire
grounding type plug, a plug having a third (grounding)
pin, it will only fit into a grounding type power outlet.
This is a safety feature. If you are unable to insert the
plug into the outlet, contact your electrician to
replace your obsolete outlet. Do not defeat the
safety purpose of the grounding type plug.
POWER-CORD PROTECTION -- Power-supply cords
should be routed so that they are not likely to be
walked on or pinched by items placed upon or
against them, paying particular attention to cords at
plugs, convenience receptacles, and the point where
they exit from the product.
OUTDOOR ANTENNA GROUNDING -- If an outside
antenna or cable system is connected to the product,
be sure the antenna or cable system is grounded so
as to provide some protection against voltage surges
and built-up static charges. Article 810 of the National
Electrical Code, ANSI/NFPA 70, provides information
with regard to proper grounding of the mast and
supporting structure, grounding of the lead-in wire
to an antenna discharge unit, size of grounding
conductors, location of antenna-discharge unit,
connection to grounding electrodes, and
requirements for the grounding electrode. See Figure
A.
LIGHTNING -- For added protection for this product
during a lightning storm, or when it is left unattended
and unused for long periods of time, unplug it from
the wall outlet and disconnect the antenna or cable
system. This will prevent damage to the product
due to lightning and power-line surges.
POWER LINES -- An outside antenna system should
not be located in the vicinity of overhead power lines
or other electric light or power circuits, or where it
can fall into such power lines or circuits. When
installing an outside antenna system, extreme care
should be taken to keep from touching such power
lines or circuits as contact with them might be fatal.
OVERLOADING -- Do not overload wall outlets,
extension cords, or integral convenience receptacles
as this can result in a risk of fire or electric shock.
OBJECT AND LIQUID ENTRY -- Never push objects of
any kind into this product through openings as they
may touch dangerous voltage points or short-out
parts that could result in a fire or electric shock.
Never spill liquid of any kind on the product.
SERVICING -- Do not attempt to service this product
yourself as opening or removing covers may expose
you to dangerous voltage or other hazards. Refer all
servicing to qualified service personnel.
DAMAGE REQUIRING SERVICE -- Unplug this product
from the wall outlet and refer servicing to qualified
service personnel under the following conditions:
¶ When the power-supply cord or plug is damaged.
¶ If liquid has been spilled, or objects have fallen into
the product.
¶ If the product has been exposed to rain or water.
¶ If the product does not operate normally by following
the operating instructions. Adjust only those controls
that are covered by the operating instructions as an
improper adjustment of other controls may result in
damage and will often require extensive work by a
qualified technician to restore the product to its
normal operation.
¶ If the product has been dropped or damaged in any
way.
¶ When the product exhibits a distinct change in
performance -- this indicates a need for service.
REPLACEMENT PARTS -- When replacement parts
are required, be sure the service technician has used
replacement parts specified by the manufacturer or
have the same characteristics as the original part.
Unauthorized substitutions may result in fire, electric
shock, or other hazards.
SAFETY CHECK -- Upon completion of any service or
repairs to this product, ask the service technician to
perform safety checks to determine that the product
is in proper operating condition.
WALL OR CEILING MOUNTING -- The product should
not be mounted to a wall or ceiling.
HEAT -- The product should be situated away from heat
sources such as radiators, heat registers, stoves, or
other products (including amplifiers) that produce
heat.
IMPORTANT SAFETY INSTRUCTIONS
GROUND
CLAMP
ANTENNA
DISCHARGE UNIT
(NEC SECTION 810-20)
GROUNDING CONDUCTORS
(NEC SECTION 810-21)
GROUND CLAMPS
POWER SERVICE GROUNDING
ELECTRODE SYSTEM
(NEC ART 250, PART H)
ELECTRIC
SERVICE
EQUIPMENT
Fig. A
ANTENNA
LEAD IN
WIRE
NEC -- NATIONAL ELECTRICAL CODE
VENTILATION -- Slots and openings in the cabinet are
provided for ventilation and to ensure reliable
operation of the product and to protect it from
overheating, and these openings must not be
blocked or covered. The openings should never be
blocked by placing the product on a bed, sofa, rug,
or other similar surface. This product should not be
placed in a built-in installation such as a bookcase or
rack unless proper ventilation is provided or the
manufacturer's instructions have been adhered to.
POWER SOURCES -- This product should be operated
only from the type of power source indicated on the
marking label. If you are not sure of the type of
power supply to your home, consult your product
dealer or local power company.
LOCATION The appliance should be installed in a
stable location.
NONUSE PERIODS The power cord of the appliance
should be unplugged from the outlet when left un-
used for a long period of time.
Information to User
Alteration or modifications carried out without appropriate authorization may invalidate the user's right to operate the equipment.
4
<ARB7135>
& DOLBY PRO LOGIC COMPATIBLE
Best suited for playing back movies and music by reproducing surround effects.
& 100 W 5 ch EQUAL POWER DISCRETE AMPLIFIER
5-channel equal power discrete amplifier enables playback of the high quality Dolby Pro Logic surround effects.
& VARIOUS SURROUND EFFECTS (DSP)
Reproduces six different surround effects.
& VIRTUAL DOLBY SURROUND
The Virtual Dolby surround function employs TruSurround* technology to create a three-dimensional sound field using
only the front right and left speakers.
& 5.1-CHANNEL INPUT
Features input terminals for center, surround L, R, and sub-woofer (LFE) channels, thus allowing the connection of Dolby
Digital decoder or DVD player provided with 5.1-channel output.
FEATURES
SWITCHING THE INPUT SIGNAL ................................................................................................. 16
TONE/BALANCE CONTROL .......................................................................................................... 17
DIGITAL NOISE REDUCTION (DNR) ............................................................................................. 17
SPEAKERS SWITCH ...................................................................................................................... 17
LISTENING TO FM/AM BROADCASTS ........................................................................................ 18
RECORDING ................................................................................................................................... 22
OPERATING OTHER COMPONENTS ............................................................................................ 24
SAT (Satellite Tuner) operation .................................................................................................24
LD PLAYER/DVD PLAYER operation ......................................................................................... 24
CD PLAYER operation ................................................................................................................ 25
CASSETTE DECK/VCR operation .............................................................................................. 26
TV operation ............................................................................................................................... 27
MODE CHECK BUTTON ................................................................................................................ 27
BASIC OPERATIONS
3.
NAMES OF PARTS ........................................................................................................................... 9
CONNECTING DEVICES ................................................................................................................ 12
NAMES AND CONNECTIONS OF PARTS
2.
CHECKING ACCESSORIES .............................................................................................................. 7
REMOTE CONTROL UNIT ............................................................................................................... 7
INSTALLATION ................................................................................................................................. 8
BEFORE USE
1.
CONTENTS
* Registered in the US and selected foreign countries.
5
<ARB7135>
1
2
3
4
5
& CONTROL OF OTHER MANUFACTURERS' EQUIPMENT USING THE
MULTI CONTROL (UNIVERSAL) REMOTE CONTROL UNIT
Can be used to operate other manufacturers' products with the multi control remote control unit by presetting and learn-
ing functions.
& DIGITAL NOISE REDUCTION (DNR)
Signals are digitally filtered into multiple frequency bands, and noise is eliminated by expanding the difference between
the music signal and the noise. This function can be used only during 2-channel operation.
& 5-D THEATER
The 5-D THEATER function provides clear dynamic sound effects by outputting audio signals through the rear channel to
simulate stereo sound.
ENJOYING SURROUND EFFECTS ............................................................................................... 28
Switching the Dolby Pro Logic surround ................................................................................. 28
Selecting the surround effects (DSP mode) ............................................................................. 31
Turning ON 5-D THEATER ......................................................................................................... 33
Selecting the virtual surround mode (Dolby Virtual/SRS*) .................................................... 34
DVD 5.1-CHANNEL INPUT MODE ................................................................................................ 35
USEFUL FUNCTIONS OF THE REMOTE CONTROL UNIT .......................................................... 36
Operating other equipment using this unit's remote control (Preset mode) ........................ 36
Memorizing other manufacturers' signals (Learning mode) .................................................. 39
Turning ON/OFF the power of several devices (Multi Operation) .......................................... 40
Performing Multi Operation ......................................................................................................41
Multi Operation/Personal Mode ................................................................................................ 42
Operating the Personal Mode ................................................................................................... 42
Turning OFF the power of the system ...................................................................................... 43
Canceling remote control settings ............................................................................................ 43
VARIOUS OPERATIONS
4.
* Registered in the US and selected foreign countries.
TROUBLESHOOTING .................................................................................................................... 44
LIST OF MANUFACTURER CODES .............................................................................................. 46
SPECIFICATIONS ........................................................................................................................... 47
OTHER
5.