PIONEER S-W3700/XJC/E - Owner's Manual Immediate Download

S-FCR4700

OPERATING GUIDE

SPEAKER SYSTEM

· Speaker stand bases x 4

· Screws (for bases) x 12

· Non-skid pads (Large)

· Operating guide

· Non-skid pads (Small)

x 4 (For subwoofer)

x 16 (For speaker stand bases)

x 4 (For center speaker)

· Speaker cords x 6

Front left (White)

Front right (Red)

Surround left (Blue)

Surround right (Grey)

Center (Green)

Subwoofer (Purple)

· Front speakers x 2

· Surround speakers x 2

· Center speaker

· Subwoofer

WHAT'S IN THE BOX

BEFORE USE

Thank you for buying this Pioneer product.

Please read through this operating guide before using your

speaker system to optimize performance.

FRONT / CENTER / SURROUND SPEAKERS

In order to prevent damage to the speaker system resulting

from input overload, please observe the following precautions:

When connecting or disconnecting cables, be sure amplifier

power is OFF.

Do not use excessive amplifier volume if using a tone control

to emphasize high or low frequencies.

SUBWOOFER

Do not place anything on top of the cabinet.

Do not spill liquid on the cabinet.

Place the subwoofer at least 8 inches from any wall or

curtain in order to avoid heat build-up.

The subwoofer is not magnetically shielded and so should

not be placed near a TV or monitor. Magnetic storage media

(such as floppy discs and tape or video cassettes) should

also not be kept close to the subwoofer.

CAUTION:

· Do not connect this speaker to any amplifier other than the

one supplied with this system. Connection to any other

amplifier may result in a malfunction or a fire.

· Do not attach the subwoofer, front and surround speakers

to the wall or ceiling. They may fall off and cause injury.

S-W3700

INSTALLATION PRECAUTIONS

FRONT / CENTER / SURROUND SPEAKERS

Do not install these units near a stove or other heating

appliance, or put them in a place exposed to the sun. Such

locations may cause the cabinet to change color and the

speaker system to break down.

The front, center and surround speakers supplied with this

system are magnetically shielded. However, placing them

extremely close to a television may result in color distortion on

the screen. If this happens, move the speakers a little further

away and switch off the television for 15 to 30 minutes.

S-FCRW4700_ASIA_En.p65

06.4.7, 4:53 PM

Assembling the speaker stands and securing your front

and surround speakers

Attach the speaker stand bases to the stems using the screws

provided.

Once you have aligned the stem and base, secure with the

small screws at the points shown below. Note that the speaker

should face in the direction of the base of the isosceles triangle

(outlined below).

Rear

Front

CONNECTING YOUR SYSTEM

IMPORTANT:

Make sure all equipment is turned off before making any

connections.

FRONT / CENTER / SURROUND / SUBWOOFER

SPEAKERS

Correct wiring of your loudspeakers is essential for achieving

the best sound quality. Be careful to ensure proper polarity of

connection.

Twist and pull off the protective shields on each wire.

Connect to the speaker terminals on the rear of the

receiver.

To connect, insert the colored wire into the matching positive

(colored) terminal and the other wire into the negative (black)

terminal as shown below.

Note that the color-coded tabs are as follows:

· Red : Front right (R)

· Purple : Subwoofer

· White : Front left (L)

· Grey : Surround right (R)

· Green : Center speaker

· Blue : Surround left (L)

Connect the speaker cords to the input terminals at the

rear of speaker.

Match the colored wire with the color-coded label (above the

tabs), then insert the colored wire into the red (+) tab and the

other wire with the black () tab.

red (+)

black ()

Colored marker

PLACEMENT AND FINE TUNING

SUBWOOFER

Sound spreads in all directions in the very low frequency range.

Human hearing cannot easily detect the source of very low

frequencies. Be sure to provide a space of at least 8 inches

(20 cm) between the rear of the subwoofer and the nearest wall.

FRONT SPEAKERS

For best results the loudspeakers should be separated a

distance approximately equal to the listening distance. Angling

the loudspeakers inward towards the listener will improve the

image stability for non-central listeners. Close proximity to a

side or rear wall will enhance the midbass performance,

although too close (particularly a corner location) and the bass

may be unnaturally high and image performance may be

degraded.

CENTER SPEAKER

The loudspeaker should be positioned below the TV. For best

results align the front of the loudspeaker with the front of the TV.

If the loudspeaker is placed under the TV and very close to the

floor, then tilting upwards may be beneficial.

When installing the center speaker on top of the TV, be sure to

secure it with tape or some other suitable means. Otherwise, the

speaker may fall from the TV due to external shocks such as

earthquakes, endangering those nearby or damaging the speaker.

STANDARD SURROUND SETUP

This is a standard multichannel surround soundspeaker setup

for optimal 5.1 channel home theater sound.

Front left

Surround

left

Listening position

Center

Subwoofer

Front right

Surround

right

S-FCRW4700_ASIA_En.p65

06.3.30, 11:53 AM

Secure each of the front and surround speakers using the metal

catch provided.

Screw two picture hooks or similar into the wall behind the

speaker. Pass a chain or cord around the hooks and through

the metal catch so that the speaker is stabilized (make sure to

test that it supports the weight of the speaker).

After installing, make sure the speaker is securely fixed.

Chain or cord

Metal catch

CAUTION:

· The metal catch is not a mounting fixture, and the speaker

should not be hung directly from the wall using this catch.

Always use a chain or cord when stabilizing the speaker.

· Pioneer disclaims all responsibility for any losses or

damage resulting from improper assembly, installation,

insufficient strength of the installation materials, misuse, or

natural disasters.

NON-SKID PADS

Attach the small non-skid pads to the base of the center

speakers. The large non-skid pads are for the front and

surround speakers, and the subwoofer (as shown).

Use the adhesive side of the pads to attach them to the base of

each speaker and the subwoofer.

Small non-skid pads

Center speaker

Large non-skid pads

Front and Surround speakers

Subwoofe

WALL MOUNTING THE CENTER SPEAKERS

The center speaker have mounting holes which can be used to

mount the speaker on the wall.

5 mm

10 mm

5 mm to 7 mm

Before mounting (see above), keep in mind the following points:

¶ Remember that the speaker system is heavy and that its

weight could cause the screws to work loose, or the wall

material to fail to support it, resulting in the speaker falling.

Make sure that the wall you intend to mount the speakers on

is strong enough to support them. Do not mount on plywood

or soft surface walls.

¶ Mounting screws are not supplied. Use screws suitable for

the wall material and support the weight of the speaker.

CAUTION:

· If you are unsure of the qualities and strength of the walls,

consult a professional for advice.

· Pioneer is not responsible for any accidents or damage

that result from improper installation.

CABINET MAINTENANCE

Use a polishing cloth or dry cloth to wipe off dust and dirt.

When the cabinet is very dirty, clean with a soft cloth dipped in

some neutral cleanser diluted five or six times with water, and

then wipe again with a dry cloth. Do not use furniture wax or

cleaners.

Never use thinners, benzine, insecticide sprays and other

chemicals on or near the cabinets, since these will corrode the

surfaces.

S-FCRW4700_ASIA_En.p65

06.3.30, 11:53 AM

TROUBLESHOOTING

SYMPTOM

1. No sound

2. Sound is distorted

PROBABLE CAUSE

· Bad speaker wire or connection

· Receiver is off

· Volume control is at zero

· Extreme signal condition

REMEDY

· Connect correctly or replace wire

· Turn on receiver

· Slowly turn up volume

· Turn down the amplifier's output level

(volume, bass control, bass boost) to

lower the level.

SPECIFICATIONS

FRONT SPEAKERS

Enclosure .................................... Closed-box floorstanding type

(magnetically shielded)

System .................................................................. 2-way system

Speakers:

Woofer ................................................. 7.7 cm cone type

× 2

Tweeter ............................................ 2.6 cm semi-dome type

Nominal impedance .............................................................. 8

Frequency range ............................................... 70 Hz to 20 kHz

Dimensions ......... 260 mm (W)

× 1 096.5 mm (H) × 260 mm (D)

Weight ............................................................................... 4.2 kg

SURROUND SPEAKERS

Enclosure .................................... Closed-box floorstanding type

(magnetically shielded)

System .................................................................. 2-way system

Speakers:

Woofer ................................................. 7.7 cm cone type

× 2

Tweeter ............................................ 2.6 cm semi-dome type

Nominal impedance .............................................................. 8

Frequency range ............................................... 70 Hz to 20 kHz

Dimensions ......... 260 mm (W)

× 1 096.5 mm (H) × 260 mm (D)

Weight ............................................................................... 4.2 kg

CENTER SPEAKER

Enclosure .......................................... Closed-box bookshelf type

(magnetically shielded)

System ...................................................... 7.7 cm 1-way system

Speakers .......................................................... 7.7 cm cone type

Nominal impedance .............................................................. 8

Frequency range ............................................... 75 Hz to 20 kHz

Dimensions ................... 270 mm (W)

× 96 mm (H) × 90 mm (D)

Weight ............................................................................. 0.78 kg

SUBWOOFER

Enclosure ..................................... Bass-reflex floorstanding type

System ....................................................... 16 cm 1-way system

Speaker ............................................................. 16 cm cone type

Nominal impedance .............................................................. 8

Frequency range .............................................. 30 Hz to 2.0 kHz

Dimensions ................ 190 mm (W) x 360 mm (H) x 320 mm (D)

Weight ............................................................................... 4.0 kg

ACCESSORIES

Speaker cords ........................................................................... 6

Non-skid pads (For subwoofer) ................................................. 4

Non-skid pads (For speaker stand bases) .............................. 16

Non-skid pads (For center speaker) .......................................... 4

Note: Specifications and design subject to possible

modification without notice due to improvements.

Published by Pioneer Corporation.

S-FCRW4700_ASIA_En.p65

06.3.30, 11:53 AM

MEDIDAS DE PRECAUCIÓN DURANTE LA

INSTALACIÓN

ALTAVOCES FRONTALES / CENTRAL / SURROUND

Ni instale estas unidades cerca de una estufa o cualquier

otro aparato de calefacción, ni las exponga a la luz del sol.

Si lo hace, las cajas de los altavoces se podrían decolorar y

las propias unidades se podría deteriorar.

Los altavoces frontales, central y surround suministrados

con este sistema incorporan una protección magnética. Sin

embargo, si los coloca demasiado cerca de un televisor,

podría provocar distorsiones de color en la pantalla. Si así

fuera, aleje los altavoces y apague el televisor entre 15 y 30

minutos.

S-FCR4700

MANUAL DE USO

SISTEMA DE ALTAVOCES

· Bases de apoyo para

altavoces x 4

· Tornillos (para bases) x 12

· Altavoces frontales

x 2

· Almohadillas antideslizantes

(grandes)

· Almohadillas antideslizantes

(pequeñas)

x 4

(para subwoofer)

x 16

(para bases de apoyo para altavoces)

x 4

(para altavoz central)

· Altavoz central

· Altavoces surround

x 2

· Subwoofer

· Cables de altavoz x 6

Frontal izquierdo

(blanco)

Frontal derecho

(rojo)

Surround izquierdo

(azul)

Surround derecho

(gris)

Central (verde)

Subwoofer (morado)

· Manual de uso

CONTENIDO DE LA CAJA

ANTES DE USAR

Gracias por comprar un producto Pioneer.

Para obtener el máximo rendimiento del equipo, lea este

manual antes de usarlo.

ALTAVOCES FRONTALES / CENTRAL / SURROUND

Para evitar daños al sistema de altavoces a causa de

una sobrecarga en el nivel de entrada, tome las

siguientes medidas de precaución:

Al conectar o desconectar los cables, asegúrese de que el

amplificador está apagado.

Si utiliza un control de tono para resaltar los agudos o

graves, no aumente demasiado el volumen del amplificador.

SUBWOOFER

No coloque objetos encima de la caja.

No derrame líquidos sobre la caja.

Sitúe el subwoofer al menos a 20 cm de cualquier pared o

cortina para evitar la acumulación de calor.

El subwoofer no incorpora protección magnética y, por lo

tanto, no se debe colocar cerca de un televisor o monitor.

Tampoco se deben dejar cerca del subwoofer soportes de

almacenamiento magnéticos tales como los disquetes,

casetes y cintas de vídeo.

ADVERTENCIA:

· No conecte este altavoz a ningún amplificador que no sea

el suministrado con el sistema. Si lo conecta a otro

amplificador, podría provocar fallos de funcionamiento e,

incluso, un incendio.

· No instale el subwoofer, el altavoz central ni los altavoces

surround en la pared o en el techo. Podrían caerse y

causar lesiones.

S-W3700

S-FCRW4700_ASIA_Sp.p65

06.3.29, 0:05 PM