ORDER NO.
PIONEER ELECTRONIC CORPORATION 4-1, Meguro 1-Chome, Meguro-ku, Tokyo 153-8654, Japan
PIONEER ELECTRONICS SERVICE, INC. P.O. Box 1760, Long Beach, CA 90801-1760, U.S.A.
PIONEER ELECTRONIC (EUROPE) N.V. Haven 1087, Keetberglaan 1, 9120 Melsele, Belgium
PIONEER ELECTRONICS ASIACENTRE PTE. LTD. 253 Alexandra Road, #04-01, Singapore 159936
PIONEER ELECTRONIC CORPORATION 1998
RRV2083
T-ZZW DEC. 1998 Printed in Japan
FOR PRECAUTION OF
REASSEMBLY AND DISASSEMBLY
The grille is attached to the cabinet by catches. Detach by pull-
ing it toward you.
The woofer is attached to the inner baffle by 4 external screws.
To detach it, unfasten those screws. To detach it, first remove
the cosmetic baffle. Then remove the woofer.
When attaching it, fit the boss of the flange into the hole on the
baffle. (Face its terminal upward.)
The tweeter is attached to the inner baffle by 2 external screws.
To detach it, unfasten those screws. To detach it, first remove
the cosmetic baffle. Then remove the tweeter.
When attaching it, fit the boss of the flange into the hole on the
baffle. (Face its terminal lower left.)
The cosmetic baffle is attached to the inner baffle by its bosses.
To detach it, pry it open by inserting a flat blade screwdriver
into its lower slot. To detach it, first remove the grille. Then
remove the cosmetic baffle.
To attach it, apply acetic vinyl adhesive slightly to the holes on
the inner baffle. Then press it to the inner baffle.
This product is component of system.
For the operating instructions, refer to the service manual RRV2080 for XC-L5.
SPEAKER SYSTEM
S-L5V-K
XC
65S
This service manual is intended for qualified service technicians; it is not meant for the
casual do-it-yourselfer. Qualified technicians have the necessary test equipment and
tools, and have been trained to properly and safely repair complex products such as
those covered by this manual.
Improperly performed repairs can adversely affect the safety and reliability
of the product and may void the warranty. If you are not qualified to perform the repair
of this product properly and safely, you should not risk trying to do so and refer the
repair to a qualified service technician.
WARNING
This product contains lead in solder and certain electrical parts contain chemicals
which are known to the state of California to cause cancer, birth defects or other
reproductive harm.
Health & Safety Code Section 25249.6 Proposition 65
2
NSP
Cabinet
FRMM-181
NSP
Baffle Board
FRNK-317
Grille
FRMG-167
NSP
Badge
FRAM-029
NSP
Punching Net
FRNC-019
NSP
Grille Frame
FRNK-349
Network ASSY
FRWN-152
NSP
Label Back
FRAN-274
Input Terminal
FRKX-013
NSP
Acoustic Absorbent
FRMV-030
Catch
FRNK-015
NSP
Duct 35
FRNK-323
Cosmetic Baffle
FRNK-343
Speaker (Woofer)
P12EC65-62D
Speaker (Tweeter)
FE52AP39-51G
Screw (for Speaker)
BPZ40P160FZB
Mark No.
Description
Part No.
SCHEMATIC DIAGRAM
For Packing
Parts marked by "NSP" are generally unavailable because they are not in our Master Spare Parts List.
The
mark found on some component parts indicates the importance of the safety factor of the part.
Therefore, when replacing, be sure to use parts of identical designation.
NOTES:
PARTS LIST
Mark No.
Description
Part No.
S-L5V-K
Speaker Cord (2m (2pcs))
FRDD-048
Non-Skid Pads
FREC-021
Protector
FRHA-160
Protection Sheet S2
FRHC-018
Packing Case
FRHG-247
Network ASSY (FRWN-152)
Woofer
1.0
µF/63V
Tweeter
INPUT
Connector
(Red)
Connector
(Blue)
Connector
(White)