ORDER NO.
PIONEER CORPORATION 4-1, Meguro 1-chome, Meguro-ku, Tokyo 153-8654, Japan
PIONEER ELECTRONICS (USA) INC. P.O. Box 1760, Long Beach, CA 90801-1760, U.S.A.
PIONEER EUROPE NV Haven 1087, Keetberglaan 1, 9120 Melsele, Belgium
PIONEER ELECTRONICS ASIACENTRE PTE. LTD. 253 Alexandra Road, #04-01, Singapore 159936
PIONEER CORPORATION 2005
RRV3239
T ZZK AUG. 2005 Printed in Japan
FOR PRECAUTION OF
REASSEMBLY AND DISASSEMBLY
The grille is attached to the cabinet by catches. Detach by pull-
ing it toward you. When attaching it, face its badge downward.
Check the vertical direction of the cabinet with the model label
on the back board.
The woofer is attached to the baffle by 4 external screws. To
detach it, first remove the grille. Then unfasten those screws.
When attaching it, face its terminal downward.
The tweeter is attached to the baffle by 3 external screws. When
attach it with the plus terminal on the right and the minus termi-
nal on the left.
SPEAKER SYSTEM
S-HF11C
XTW/UC
65S
This service manual is intended for qualified service technicians; it is not meant for the
casual do-it-yourselfer. Qualified technicians have the necessary test equipment and
tools, and have been trained to properly and safely repair complex products such as
those covered by this manual.
Improperly performed repairs can adversely affect the safety and reliability
of the product and may void the warranty. If you are not qualified to perform the repair
of this product properly and safely, you should not risk trying to do so and refer the
repair to a qualified service technician.
WARNING
This product contains lead in solder and certain electrical parts contain chemicals
which are known to the state of California to cause cancer, birth defects or other
reproductive harm.
Health & Safety Code Section 25249.6 Proposition 65
2
1
23
4
12
3
4
C
D
F
A
B
E
S-HF11C
Parts marked by "NSP" are generally unavailable because they are not in our Master Spare Parts List.
The
mark found on some component parts indicates the importance of the safety factor of the part.
Therefore, when replacing, be sure to use parts of identical designation.
NOTES:
PARTS LIST
Mark No.
Description
Part No.
SCHEMATIC DIAGRAM
1
Protector
SHA2528
2
Protection Sheet
SHC1839
3
Packing Case
SHG2691
4
Operating Instructions
SRD1305
(English, French)
2
Speaker System
4
2
1
1
3
Mark No.
Description
Part No.
Network Assy
SWN1767
Grille
SMG1857
Input Terminal
SKX1100
Speaker (Tweeter)
SWD9007
Speaker (Woofer)
SWM9021
Screw (for Tweeter)
BYC30P180FZB
Screw (for Woofer)
BKC35P180FZB
For Packing
Speaker System
Network Assy (SWN1767)
C
I N
Black
Blue
Black
Red
Black
Red
1.8
µF/50V
Woofer
T135/60
P.SW
Tweeter
Woofer
P.SW
P.SW has extreme positive resistance-temperature characteristics. (Less than 0.3W at
the normal temperature). If an abnormal current flows to P.SW due to an excessive
input or unusual signal, P.SW heats up and the resistance rapidly increases. With this
function, the speakers are protected from excessive input or unusual signal. The
resistance value increases even when using a soldering iron for repairing, so allow it to
cool before using.
3
1
23
4
1
2
3
4
C
D
F
A
B
E
S-HF11C
1
1
2
Input Terminal
1
1
12
1
Screw
11
8
3
1
10
1
1
4
Part Name
No.
Num.
9
8
7
6
5
4
3
2
1
Catch
Screw
Grille
Cabinet
Model Label
Duct
Network Assy
Acoustic Absorbent
Woofer
Tweeter
PRODUCT APPEARANCE