ORDER NO.
PIONEER CORPORATION 4-1, Meguro 1-chome, Meguro-ku, Tokyo 153-8654, Japan
PIONEER ELECTRONICS (USA) INC. P.O. Box 1760, Long Beach, CA 90801-1760, U.S.A.
PIONEER EUROPE NV Haven 1087, Keetberglaan 1, 9120 Melsele, Belgium
PIONEER ELECTRONICS ASIACENTRE PTE. LTD. 253 Alexandra Road, #04-01, Singapore 159936
PIONEER CORPORATION 2008
Center
Front
Surround
S-DV390T
RRV3799
T-ZZR JULY 2008 Printerd in Japan
SPEAKER SYSTEM
S-DV390T
/SXTW/WL5
This service manual is intended for qualified service technicians; it is not meant for the casual
do-it-yourselfer. Qualified technicians have the necessary test equipment and tools, and have been
trained to properly and safely repair complex products such as those covered by this manual.
Improperly performed repairs can adversely affect the safety and reliability of the product and may
void the warranty. If you are not qualified to perform the repair of this product properly and safely,
you should not risk trying to do so and refer the repair to a qualified service technician.
WARNING
This product contains certain electrical parts contain chemicals which are known to the State of California to cause cancer,
birth defects or other reproductive harm.
Health & Safety Code Section 25249.6 - Proposition 65
2
S-DV390T
1
2
3
4
C
D
F
A
B
E
1
2
3
4
1. REASSEMBLY AND DISASSEMBLY PRECAUTIONS
1.1 FRONT SPEAKER
GRILLE
The grille is attached to the cabinet by its bosses applied with
adhesive. To detach it, pry it open by inserting a flat blade
screwdriver into lower right and lower left slot. To attach it, apply
adhesive to the holes on the baffle. Then press it to the baffle.
CAUTION
There are 12 bosses for press-fitting at the grille. To detach the
grille, remove in order from lower bosses. (Refer to the figure
in page 4.) In order not to damage the bosses, don't remove it
forcibly. Pry it open little by little. Be sure to insert a flat blade
screwdriver from just beside of its bosses.
WOOFER
The woofer is attached to the baffle by 4 external screws. To
detach it, unfasten those screws. To detach it, first remove the
grille. Then remove the screws. When attaching it, face its
terminal downward.
TWEETER
The tweeter is attached to the baffle by 3 external screws. To
detach it, unfasten those screws. To detach it, first remove the
grille. Then remove the screws. When attaching it, face its
terminal leftward and rightward.
COSMETIC PANEL
The cosmetic panel is attached to the baffle by its bosses. To
detach it, pry it open by inserting a flat blade screwdriver into
lower slot. To detach it, first remove the speaker stand base and
grille. Then remove the cosmetic panel. When attaching it, fit the
boss into the hole on the baffle.
SPEAKER STAND BASES
The speaker stand base is attached to the bottom of cabinet by 3
external screws. To detach it, unfasten those screws. Attach the
speaker stand bases to the stems using the screws provided. Once
you have aligned the stem and base, secure with the small screws
at the points shown below. Note that the speaker should face in
the direction of the base of the isosceles triangle (outlined below).
1.2 CENTER SPEAKER
GRILLE
The grille is attached to the cabinet by 8 external screws. To
detach it, unfasten those screws.
SPEAKER UNIT
The speaker unit, together with the grille, is attached to the
cabinet by 4 external screws. To detach it, first unfasten those
screws. Next remove the cabinet. Then remove the cable. When
re-attaching it, face its terminal toward the leftward.
1.3 SURROUND SPEAKER
GRILLE
The grille is attached to the cabinet by 4 external screws. To
detach it, unfasten those screws.
SPEAKER UNIT
The speaker unit, together with the grille, is attached to the
cabinet by 4 external screws. To detach it, first unfasten those
screws. Next remove the cabinet. Then remove the cable. When
re-attaching it, face its terminal downward.
Speaker Stand Base
Stem
(the bottom of cabinet)
Front
Rear
3
S-DV390T
5
6
7
8
5
6
7
8
C
D
F
A
B
E
2. EXPLODED VIEWS AND PARTS LIST
Parts marked by "NSP" are generally unavailable because they are not in our Master Spare Parts List.
The
mark found on some component parts indicates the importance of the safety factor of the part.
Therefore, when replacing, be sure to use parts of identical designation.
NOTES:
2.1 PACKING
NSP 1
CS Assy (Front)
SMW6274
NSP 2
CS Assy (Center)
SMW6275
NSP 3
CS Assy (Surround)
SMW6279
4
Speaker Cord (FL: White)
SDS1174
5
Speaker Cord (FR: Red)
SDS1175
6
Speaker Cord (SL: Blue)
SDS1176
7
Speaker Cord (SR: Gray)
SDS1177
8
Speaker Cord (C: Green)
SDS1178
9
Screw (for Speaker Stand Base)
CYC40P300FTC
10
Polyethylene Bag S0 (for Screw)
SHL1314
11
Non Skid Pad
SEP6015
(for Speaker Stand Base)
12
Non Skid Pad (for Surround)
SEP6027
13
Polyethylene Bag
SHL1251
(for Accessory Set)
14
Polyethylene BagS2
SHL1417
(for Center Sp)
15
Speaker Stand Base
SMS6033
16
Protector (Top)
SHA6166
17
Protector (Top)
SHA6167
18
Protector (Bottom)
SHA6168
19
Protector (Bottom)
SHA6169
20
Protector (Top)
SHA6170
21
Spacer
SHB6057
22
Protection Sheet
SHC6051
23
Protection Sheet
SHC6082
(for Speaker Stand Base)
24
Polyethylene Bag S2
SHL1420
(for Surround Sp)
25
Packing Case
SHG6365
PACKING Parts List
Mark No.
Description
Part No.
Mark No.
Description
Part No.
4
S-DV390T
1
2
3
4
C
D
F
A
B
E
1
2
3
4
2.2 CS Assy (FRONT)
Speaker Stand Base
(refer to 2.1 PACKING / No.15)
Screw (x3)
(refer to 2.1 PACKING / No.9)
Model Label
Red
White
Red
Black
: the attached to
the applied with
adhesive.
1
Grille
SMG6141
2
Cosmetic Plate Assy
SNK6222
3
Input Terminal
SKX1060
4
Fastener
SNB6003
5
Network Assy
SWN6028
6
Speaker (for Woofer)
K77DR55-56C
7
Speaker (for Tweeter)
FK26AP32-51G
8
Screw (for Tweeter)
BYC35P160FTC
9
Screw (for Woofer)
BYC35P120FTC
10
Screw (for Fastener)
BYC35P120FTB
11
Badge Plate
SNK6221
CS Assy (FRONT) Parts List
Mark No.
Description
Part No.
Mark No.
Description
Part No.
5
S-DV390T
5
6
7
8
5
6
7
8
C
D
F
A
B
E
2.3 CS Assy (CENTER)
Cabinet
5
8
2
Model Label
10
(x8)
4
9
11
12
1
Grille
SMG6129
2
Connecting Cord
SDD1345
3
Input Terminal
SKX6034
4
Speaker
K77DR55-55C
5
Screw (for Input Terminal)
BPZ35P080FTC
6
Screw (for Cabinet)
BPZ35P110FTB
7
Non Skid Pads
SEP1263
8
Non Skid Pad
SEP6028
CS Assy (CENTER) Parts List
Mark No.
Description
Part No.