The exclamation point within an equilateral
triangle is intended to alert the user to the
presence of important operating and
maintenance (servicing) instructions in the
literature accompanying the appliance.
The lightning flash with arrowhead symbol,
within an equilateral triangle, is intended to
alert the user to the presence of uninsulated
"dangerous voltage" within the product's
enclosure that may be of sufficient
magnitude to constitute a risk of electric
shock to persons.
CAUTION:
TO PREVENT THE RISK OF ELECTRIC
SHOCK, DO NOT REMOVE COVER (OR
BACK). NO USER-SERVICEABLE PARTS
INSIDE. REFER SERVICING TO QUALIFIED
SERVICE PERSONNEL.
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
IMPORTANT
D3-4-2-1-1_En-A
Replacement and mounting of an AC plug on the power supply cord of this unit should be performed only by qualified
service personnel.
IMPORTANT: THE MOULDED PLUG
This appliance is supplied with a moulded three pin mains plug for your safety and convenience. A 13 amp fuse is fitted in this plug. Should the
fuse need to be replaced, please ensure that the replacement fuse has a rating of 13 amps and that it is approved by ASTA or BSI to BS1362.
Check for the ASTA mark
or the BSI mark
on the body of the fuse.
If the plug contains a removable fuse cover, you must ensure that it is refitted when the fuse is replaced. If you lose the fuse cover the plug
must not be used until a replacement cover is obtained. A replacement fuse cover can be obtained from your local dealer.
If the fitted moulded plug is unsuitable for your socket outlet, then the fuse shall be removed and the plug cut off and disposed of
safely. There is a danger of severe electrical shock if the cut off plug is inserted into any 13 amp socket.
If a new plug is to be fitted, please observe the wiring code as shown below. If in any doubt, please consult a qualified electrician.
WARNING : THIS APPARATUS MUST BE EARTHED.
IMPORTANT: The wires in this mains lead are coloured in accordance with the following code:
Green & Yellow : Earth
Blue : Neutral
Brown : Live
As the colours of the wires in the mains lead of this appliance may not correspond with the coloured markings identifying the terminals in
your plug, proceed as follows ;
The wire which is coloured GREEN-AND-YELLOW must be connected to the terminal in the plug which is marked with the letter
E or
by the earth symbol
or coloured GREEN or GREEN-AND-YELLOW.
The wire which is coloured BLUE must be connected to the terminal which is marked with the
letter
N or coloured BLACK.
The wire which is coloured BROWN must be connected to the terminal which is marked with the
letter
L or coloured RED.
How to replace the fuse: Open the fuse compartment with a screwdriver and replace the fuse.
D3-4-2-1-2-1_B_En
If you want to dispose this product, do not mix it with general household waste. There is a separate collection system for used
electronic products in accordance with legislation that requires proper treatment, recovery and recycling.
Private households in the member states of the EU, in Switzerland and Norway may return their used electronic products free of charge to
designated collection facilities or to a retailer (if you purchase a similar new one).
For countries not mentioned above, please contact your local authorities for the correct method of disposal.
By doing so you will ensure that your disposed product undergoes the necessary treatment, recovery and recycling and thus prevent potential
negative effects on the environment and human health.
K058_A_En
WARNING
This equipment is not waterproof. To prevent a fire
or shock hazard, do not place any container filed
with liquid near this equipment (such as a vase or
flower pot) or expose it to dripping, splashing, rain
or moisture.
D3-4-2-1-3_A_En
The following symbols are found on labels attached
to the product. They alert the operators and service
personnel of this equipment to any potentially
dangerous conditions.
This product complies with the Low Voltage Directive
2006/95/EC and EMC Directive 2004/108/EC.
WARNING
This product equipped with a three-wire grounding
(earthed) plug - a plug that has a third (grounding)
pin. This plug only fits a grounding-type power
outlet. If you are unable to insert the plug into an
outlet, contact a licensed electrician to replace the
outlet with a properly grounded one. Do not
defeat the safety purpose of the grounding plug.
D3-4-2-1-6_A_En
CAUTION
The
STANDBY/ON switch on this unit will not
completely shut off all power from the AC outlet.
Since the power cord serves as the main disconnect
device for the unit, you will need to unplug it from
the AC outlet to shut down all power. Therefore,
make sure the unit has been installed so that the
power cord can be easily unplugged from the AC
outlet in case of an accident. To avoid fire hazard,
the power cord should also be unplugged from the
AC outlet when left unused for a long period of time
(for example, when on vacation).
D3-4-2-2-2a_A_En
WARNING
CAUTION
This symbol refers to a hazard or unsafe practice
which can result in personal injury or property
damage.
This symbol refers to a hazard or unsafe practice
which can result in severe personal injury or death.
VENTILATION CAUTION
When installing this unit, make sure to leave space
around the unit for ventilation to improve heat
radiation. For the minimum space required, see
page 12.
WARNING
Slots and openings in the cabinet are provided for
ventilation to ensure reliable operation of the
product, and to protect it from overheating. To
prevent fire hazard, the openings should never be
blocked or covered with items (such as
newspapers, table-cloths, curtains) or by operating
the equipment on thick carpet or a bed.
STANDBY/ON Button
STANDBY: When placed into the standby mode,
the main power flow is cut and the unit is no
longer fully operational.
STANDBY Indicator: When the STANDBY
indicator lights red, the unit is in the standby
mode.
Power ON indicator: When the power ON
indicator lights blue, the unit is in the power on
mode.
Operating Environment
Operating environment temperature and humidity:
+0 ºC to +40 ºC (+32 ºF to +104 ºF); less than 85 %RH
(cooling vents not blocked)
Do not install this unit in a poorly ventilated area, or in
locations exposed to high humidity or direct sunlight (or
strong artificial light)
D3-4-2-1-7c_A_En
WARNING
To prevent a fire hazard, do not place any naked
flame sources (such as a lighted candle) on the
equipment.
D3-4-2-1-7a_A_En
Contents
4
En
Thank you for buying this Pioneer product.
Please read through these operating instructions so you will know how to operate your model properly. After you
have finished reading the instructions, put them away in a safe place for future reference.
In some countries of regions, the shape of the power plug and power outlet may sometimes differ from that shown
in the explanatory drawings. However the method of connecting and operating the unit are the same.
Contents
01 Important user information
. . . . . . . . . .5
02 Safety precautions
. . . . . . . . . . . . . . . . .6
03 Features
. . . . . . . . . . . . . . . . . . . . . . . . . .7
04 Supplied accessories
. . . . . . . . . . . . . . . .8
05 Part names
. . . . . . . . . . . . . . . . . . . . . . . .9
Front
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9
Rear
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10
Remote control unit
. . . . . . . . . . . . . . . . . . . . . . . . . 11
06 Preparation
. . . . . . . . . . . . . . . . . . . . . .12
Installing the unit
. . . . . . . . . . . . . . . . . . . . . . . . . . . 12
Preparing the remote control unit
. . . . . . . . . . . . . . 12
Operating range of the remote control unit
. . . . . . . 13
07 Using the unit
. . . . . . . . . . . . . . . . . . . .14
Connecting the unit to a Pioneer plasma television
(see Chapter 8)
. . . . . . . . . . . . . . . . . . . . . . . . . . . . 15
Connecting the unit to other televisions
(see Chapter 9)
. . . . . . . . . . . . . . . . . . . . . . . . . . . . 15
08 Using the unit with a Pioneer plasma
television
. . . . . . . . . . . . . . . . . . . . . . . . . .16
09 Using the unit with other
televisions
. . . . . . . . . . . . . . . . . . . . . . . . .17
10 Advanced functions
. . . . . . . . . . . . . . .18
Connecting control cables
. . . . . . . . . . . . . . . . . . . . 18
Changing settings
. . . . . . . . . . . . . . . . . . . . . . . . . . 19
11 Using with other components
. . . . . . .21
Connections to a television
. . . . . . . . . . . . . . . . . . . 21
Connections to input components
. . . . . . . . . . . . . . 21
Using the HDMI input
. . . . . . . . . . . . . . . . . . . . . . . 22
Connections to a HDMI-supported component
. . . . 22
About HDMI
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 22
Connections to a component equipped with SCART
connector
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 23
Connections to a component with component
connectors
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 23
12 Additional information
. . . . . . . . . . . .24
Troubleshooting
. . . . . . . . . . . . . . . . . . . . . . . . . . . . 24
SCART pin assignments
. . . . . . . . . . . . . . . . . . . . . . 26
Specifications
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . 27
Operation of the unit's indicators
. . . . . . . . . . . . . . . 28
Important user information
01
5
En
English
Chapter 1
Important user information
In order to obtain maximum enjoyment from this unit,
please first read this information carefully.
Do not attach such items as labels and tape to
the product.
This may result in the discolouration or scratch of the
cabinet.
When not using the product for a long period of
time
If you do not use the product for a long period of time,
the functions of the product may be adversely affected.
Switch on and run the product occasionally.
Condensation
Condensation may take place on the surface or inside
of the product when the product is rapidly moved from
a cold place to a warm place or just after a heater is
switched on in winter morning, for example. When
condensation takes place, do not switch on the product
and wait until condensation disappears. Using the
product with condensation may result in malfunction.
Cleaning the cabinet
When cleaning the cabinet of this product, gently wipe
it with a clean soft cloth (e.g., cotton and flannel). If you
use a dusty or hard cloth or if you rub the cabinet hard,
the surface of the cabinet will be scratched.
The cabinet of this product is mostly composed of
plastic. Do not use chemicals such as benzene or
thinner to clean the cabinet. Using these chemicals
may result in quality deterioration or coating removal.
Do not expose the product to volatile gas or fluid such
as pesticide. Do not make the product contact with
rubber or vinyl products for a long period of time. The
effect of plasticizer in the plastic may result in quality
deterioration or coating removal.
If you clean the surface of the cabinet with a wet cloth,
water droplets on the surface may enter into the
product, resulting in malfunction.