En
Integrated Amplifier
A-9755/A-9555
Instruction Manual
Thank you for purchasing an Onkyo Integrated Ampli-
fier. Please read this manual thoroughly before making
connections and plugging in the unit.
Following the instructions in this manual will enable
you to obtain optimum performance and listening
enjoyment from your new Integrated Amplifier.
Please retain this manual for future reference.
Contents
Introduction .................................... 2
Connections ................................. 10
Enjoying Audio Sources.............. 14
Troubleshooting ........................... 18
Specifications ...... Back cover page
2
Important Safety Instructions
1. Read these instructions.
2. Keep these instructions.
3. Heed all warnings.
4. Follow all instructions.
5. Do not use this apparatus near water.
6. Clean only with dry cloth.
7. Do not block any ventilation openings. Install in
accordance with the manufacturer's instructions.
8. Do not install near any heat sources such as radia-
tors, heat registers, stoves, or other apparatus
(including amplifiers) that produce heat.
9. Do not defeat the safety purpose of the polarized or
grounding-type plug. A polarized plug has two
blades with one wider than the other. A grounding
type plug has two blades and a third grounding
prong. The wide blade or the third prong are pro-
vided for your safety. If the provided plug does not
fit into your outlet, consult an electrician for
replacement of the obsolete outlet.
10. Protect the power cord from being walked on or
pinched particularly at plugs, convenience recepta-
cles, and the point where they exit from the appara-
tus.
11. Only use attachments/accessories specified by the
manufacturer.
12. Use only with the cart, stand,
tripod, bracket, or table spec-
ified by the manufacturer, or
sold
with
the
apparatus.
When a cart is used, use cau-
tion
when
moving
the
cart/apparatus
combination
to avoid injury from tip-over.
13. Unplug this apparatus during lightning storms or
when unused for long periods of time.
14. Refer all servicing to qualified service personnel.
Servicing is required when the apparatus has been
damaged in any way, such as power-supply cord or
plug is damaged, liquid has been spilled or objects
have fallen into the apparatus, the apparatus has
been exposed to rain or moisture, does not operate
normally, or has been dropped.
15. Damage Requiring Service
Unplug the apparatus from the wall outlet and refer
servicing to qualified service personnel under the
following conditions:
A. When the power-supply cord or plug is dam-
aged,
B. If liquid has been spilled, or objects have fallen
into the apparatus,
C. If the apparatus has been exposed to rain or
water,
D. If the apparatus does not operate normally by
following the operating instructions. Adjust only
those controls that are covered by the operating
instructions as an improper adjustment of other
controls may result in damage and will often
require extensive work by a qualified technician
to restore the apparatus to its normal operation,
E. If the apparatus has been dropped or damaged in
any way, and
F. When the apparatus exhibits a distinct change in
performance this indicates a need for service.
16. Object and Liquid Entry
Never push objects of any kind into the apparatus
through openings as they may touch dangerous volt-
age points or short-out parts that could result in a
fire or electric shock.
The apparatus shall not be exposed to dripping or
splashing and no objects filled with liquids, such as
vases shall be placed on the apparatus.
Don't put candles or other burning objects on top of
this unit.
17. Batteries
Always consider the environmental issues and fol-
low local regulations when disposing of batteries.
18. If you install the apparatus in a built-in installation,
such as a bookcase or rack, ensure that there is ade-
quate ventilation.
Leave 20 cm (8") of free space at the top and sides
and 10 cm (4") at the rear. The rear edge of the shelf
or board above the apparatus shall be set 10 cm (4")
away from the rear panel or wall, creating a flue-like
gap for warm air to escape.
WARNING:
TO REDUCE THE RISK OF FIRE OR ELECTRIC
SHOCK, DO NOT EXPOSE THIS APPARATUS
TO RAIN OR MOISTURE.
CAUTION:
TO REDUCE THE RISK OF ELECTRIC SHOCK,
DO NOT REMOVE COVER (OR BACK). NO
USER-SERVICEABLE PARTS INSIDE. REFER
SERVICING
TO
QUALIFIED
SERVICE
PERSONNEL.
The lightning flash with arrowhead symbol, within an
equilateral triangle, is intended to alert the user to the
presence of uninsulated "dangerous voltage" within
the product's enclosure that may be of sufficient
magnitude to constitute a risk of electric shock to
persons.
The exclamation point within an equilateral triangle is
intended to alert the user to the presence of important
operating and maintenance (servicing) instructions in
the literature accompanying the appliance.
WARNING
RISK OF ELECTRIC SHOCK
DO NOT OPEN
RISQUE DE CHOC ELECTRIQUE
NE PAS
OUVRIR
AVIS
PORTABLE CART WARNING
S3125A
3
Precautions
1. Recording Copyright--Unless it's for personal use
only, recording copyrighted material is illegal with-
out the permission of the copyright holder.
2. AC Fuse--The AC fuse inside the unit is not user-
serviceable. If you cannot turn on the unit, contact
your Onkyo dealer.
3. Care--Occasionally you should dust the unit all
over with a soft cloth. For stubborn stains, use a soft
cloth dampened with a weak solution of mild deter-
gent and water. Dry the unit immediately afterwards
with a clean cloth. Don't use abrasive cloths, thin-
ners, alcohol, or other chemical solvents, because
they may damage the finish or remove the panel let-
tering.
4. Power
WARNING
BEFORE PLUGGING IN THE UNIT FOR THE
FIRST TIME, READ THE FOLLOWING SEC-
TION CAREFULLY.
AC outlet voltages vary from country to country.
Make sure that the voltage in your area meets the
voltage requirements printed on the unit's rear panel
(e.g., AC 230 V, 50 Hz or AC 120 V, 60 Hz).
Some models have a voltage selector switch for
compatibility with power systems around the world.
Before you plug in such a model, make sure that the
voltage selector is set to the correct voltage for your
area.
5. Never Touch this Unit with Wet Hands--Never
handle this unit or its power cord while your hands
are wet or damp. If water or any other liquid gets
inside this unit, have it checked by your Onkyo
dealer.
6. Handling Notes
· If you need to transport this unit, use the original
packaging to pack it how it was when you origi-
nally bought it.
· Do not leave rubber or plastic items on this unit
for a long time, because they may leave marks on
the case.
· This unit's top and rear panels may get warm
after prolonged use. This is normal.
· If you do not use this unit for a long time, it may
not work properly the next time you turn it on, so
be sure to use it occasionally.
For British models
Replacement and mounting of an AC plug on the power
supply cord of this unit should be performed only by
qualified service personnel.
IMPORTANT
The wires in the mains lead are coloured in accordance
with the following code:
Blue:
Neutral
Brown:
Live
As the colours of the wires in the mains lead of this
apparatus may not correspond with the coloured mark-
ings identifying the terminals in your plug, proceed as
follows:
The wire which is coloured blue must be connected to
the terminal which is marked with the letter N or
coloured black.
The wire which is coloured brown must be connected to
the terminal which is marked with the letter L or
coloured red.
IMPORTANT
The plug is fitted with an appropriate fuse. If the fuse
needs to be replaced, the replacement fuse must
approved by ASTA or BSI to BS1362 and have the
same ampere rating as that indicated on the plug. Check
for the ASTA mark or the BSI mark on the body of the
fuse.
If the power cord's plug is not suitable for your socket
outlets, cut it off and fit a suitable plug. Fit a suitable
fuse in the plug.
For European Models
Declaration of Conformity
We, ONKYO EUROPE
ELECTRONICS GmbH
LIEGNITZERSTRASSE 6,
82194 GROEBENZELL,
GERMANY
GROEBENZELL, GERMANY
ONKYO EUROPE ELECTRONICS GmbH
K. MIYAGI
declare in own responsibility, that the ONKYO product
described in this instruction manual is in compliance with the
corresponding
technical standards such as EN60065,
EN55013, EN55020 and EN61000-3-2, -3-3.
4
Table of Contents
Features
A-9755 Integrated Digital Amplifier
150 W/Ch into 8 ohms, DIN/300 W/Ch into 4
ohms, JEITA
Exclusive Onkyo VL Digital Technology
Pure Stream Power Supply (2 Transformers)
All Discrete Output Stage Circuitry
Low-Impedance, Thick Bus Plate
Optimum Gain Volume Circuitry
Audiophile-Grade Capacitor
Precision Motor Volume Control
Tone Control (Bass, Treble, Loudness
On/Off)
Pure Direct Mode
Discrete Phono Equalizer
7 Gold-Plated Audio Inputs and 2 Outputs
Main In Terminal
Blue Illuminated Volume Control
Hi-Rigidity, Anti-Resonant Chassis and
Brass Stabilizers
Gold-Plated, Banana Plug-Compatible
Transparent Speaker Terminals
Heavy-Duty Power Cord
Compatible with RI Dock for the iPod
RI (Remote Interactive) Remote Control
A-9555 Integrated Digital Amplifier
100 W/Ch into 8 ohms, DIN/200 W/Ch into 4
ohms, JEITA
Exclusive Onkyo VL Digital Technology
Pure Stream Power Supply
Discrete Output Stage Circuitry
Low-Impedance, Thick Bus Plate
Optimum Gain Volume Circuitry
Precision Motor Volume Control
Tone Control (Bass, Treble, Loudness
On/Off)
Pure Direct Mode
Discrete Phono Equalizer
7 Audio Inputs and 2 Outputs
Hi-Rigidity, Anti-Resonant Chassis
Aluminum Volume and Selector Knob
Banana Plug-Compatible Speaker Terminals
Compatible with RI Dock for the iPod
RI (Remote Interactive) Remote Control
Important Safety Instructions .................. 2
Precautions ............................................... 3
Table of Contents...................................... 4
Features ..................................................... 4
Supplied Accessories............................... 5
Connecting the Supplied Power Cord .....5
Installing the Remote Controller's
Batteries..............................................5
Front & Rear Panels.................................. 6
Front Panel .............................................6
Rear Panel ..............................................7
Remote Controller..................................... 8
Using the Remote Controller ..................9
Introduction
Connecting the A-9755/A-9555 .............. 10
Connecting Your Speakers ...................10
Before Making any Connections ...........11
Audio Components ...............................11
Connecting a Turntable...................... 11
Connecting a CD Player..................... 11
Connecting a Tuner............................ 12
Connecting a Cassette Deck.............. 12
Connecting an MD Recorder.............. 12
Connecting a Remote Interactive Dock
(RI Dock) ...................................... 12
Connecting a TV or Other Component
with an Audio Output .................... 12
Connecting a Preamp (A-9755 only) ..... 13
Connecting
Components ............. 13
Connections
Turning On the A-9755/A-9555.............14
Selecting Speaker.................................14
Listening to Components ......................15
Muting the A-9755/A-9555 (remote
controller only) .............................. 15
Using Headphones............................. 15
Using the Tone Controls .......................16
Setting the PURE DIRECT Function ....16
Adjusting the Bass ............................. 16
Adjusting the Treble ........................... 16
Loudness Control..................................16
Using the MAIN IN Function (A-9755
only) ................................................ 17
Recording .............................................17
Enjoying Audio Sources
Troubleshooting...................................... 18
Specifications.......................................... 20
Others
5
Supplied Accessories
Make sure you have the following accessories:
In catalogs and on packaging, the letter added to the end
of the product name indicates the color of the
A-9755/A-9555. Specifications and operation are the
same regardless of color.
Plug the supplied power cord into this AC INLET.
· Do not use a power cord other than the one supplied
with the A-9755/A-9555. The power cord supplied is
designed for use with the A-9755/A-9555 and should
not be used with any other device.
· Never have the power cord disconnected from the
A-9755/A-9555 while the other end is plugged into
the wall outlet. Doing so may cause an electric shock.
Always connect by plugging into the wall outlet last
and disconnect by unplugging from the wall outlet
first.
Notes:
· If the remote controller doesn't work reliably, try
replacing the batteries.
· Don't mix new and old batteries or different types of
batteries.
· If you intend not to use the remote controller for a
long time, remove the batteries to prevent damage
from leakage or corrosion.
· Flat batteries should be removed as soon as possible
to prevent damage from leakage or corrosion.
Connecting the Supplied Power Cord
Remote controller & two batteries (AA/R6)
A-9755: RC-636S
A-9555: RC-627S
Power cord
(Power cord varies from
country to country)
To wall outlet
DO NOT connect the
power cord at this
time.
Installing the Remote Controller's
Batteries
1 To open the battery compartment, press
the small hollow and slide open the cover.
2 Insert the two supplied batteries (AA/R6)
in accordance with the polarity diagram
inside the battery compartment.
3 Slide the cover shut.