Model CDR510 User Guide
CD Recorder/CD Player
Recordable
®
CLASS 1 LASER PRODUCT
LOUKAN 1 LASERLAITE
KLASS 1 LASERAPPARAT
- 2 -
RISK OF ELECTRIC SHOCK
DO NOT OPEN
CAUTION
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK,
DO NOT REMOVE COVER (OR BACK)
NO USER-SERVICEABLE PARTS INSIDE
REFER SERVICING TO QUALIFIED SERVICE PERSONNEL
The lightning flash with arrowhead symbol, within
an equilateral triangle, is intended to alert the user
to the presence of uninsulated "dangerous voltage"
within the product's enclosure that may be of
sufficient magnitude to constitute a risk of electric
shock to persons.
The exclamation point within an equilateral triangle
is intended to alert the user to the presence of
important operating and maintenance (servicing)
instructions in the literature accompanying the
appliance.
WARNING
TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK,
DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.
LASER SAFETY
This unit employs lasers. Only a qualified service person
should remove the cover or attempt to service this device, due
to possible eye injury.
CAUTION USE OF CONTROLS OR ADJUSTMENTS
OR PERFORMANCE OF PROCEDURE
OTHER THAN THOSE SPECIFIED HEREIN
MAY RESULT IN HAZARDOUS RADIATION
EXPOSURE.
Warnings and Cautions
NOTE TO CATV SYSTEM INSTALLER:
This reminder is provided to call the CATV (Cable-
TV) system installer's attention to Article 820-40 of
the NEC, which provides guidelines for proper ground-
ing and, in particular, specifies that the cable ground
shall be connected to the grounding system of the
building, as close to the point of cable entry as
practical.
NEC - NATIONAL ELECTRICAL CODE
ANTENNA
LEAD IN
WIRE
GROUND
CLAMP
ANTENNA
DISCHARGE
UNIT
(NEC SECTION
810-20)
GROUNDING
CONDUCTORS
(NEC SECTION
810-21)
ELECTRIC
SERVICE
EQUIPMENT
GROUND CLAMPS
POWER SERVICE
GROUNDING
ELECTRODE SYSTEM
(NEC ART 250, PART H)
NOTE:
This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful in-
terference in a residential installation. This equipment
generates, uses and can radiate radio frequency en-
ergy and, if not installed and used in accordance with
the instructions, may cause harmful interference to
radio communications. However, there is no guaran-
tee that interference will not occur in a particular
installation. If this equipment does cause harmful
interference to radio or television reception, which can
be determined by turning the equipment off and on,
the user is encouraged to try to correct the interfer-
ence by one or more of the following measures:
· Re-orient or relocate the receiving antenna.
· Increase the separation between the equipment
and receiver.
· Connect the equipment into an outlet on a circuit
different from that to which the receiver is con-
nected.
· Consult the dealer or an experienced radio/TV
technician for help.
NOTE: Changes or modifications may cause this
unit to fail to comply with Part 15 of the FCC Rules
and may void the user's authority to operate the
equipment.
This Class B digital apparatus complies
with Canadian ICES-003.
Cet appareil numérique de la Classe B est
conforme á la norme NMB-003 du Canada.
FIGURE 1
EXAMPLE OF ANTENNA GROUNDING AS PER
NATIONAL ELECTRICAL CODE, ANSI/NFPA 70
- 3 -
Do not expose the equipment to rain or moisture.
Do not remove the cover from the equipment.
Do not insert anything into the equipment through
the ventilation holes.
Do not handle the mains lead with wet hands.
Do not cover the ventilation with any items such
as tablecloths, newspapers, curtains, etc.
No open flame sources, such as lighted candles,
should be placed on the equipment.
When disposing of used batteries, please comply
with governmental regulations or environmental
public instruction's rules that apply in your country
or area.
WARNINGS
CE marking (only EU version)
This product is in conformity with the EMC
directive and low-voltage directive.
Equipment mains working system
This product complies with household power and
safety requirements in your area. CDR510 can be
powered by 120 V AC only.
Copyright
Recording and play back of any material may
require consent. For further information refer to
the following US ordinances:
· Copyright act of 1956
· Dramatic and Musical Performance Act 1958
· Performers Protection Acts 1963 and 1972
· any subsequent statutory enactments and
orders
Precautions - installation
· Do not expose the CDR510 to excessive heat,
excessive cold, rain, moisture, or dust this may
cause damage to the unit.
· If a foreign object or water does enter the unit,
contact your nearest dealer or service center.
· All players produce some heat during operation and
this heat must be allowed to dissipate freely. Do not
close any ventilation openings and be sure there is
adequate ventilation space behind, beside and
above the player so air is allowed to circulate freely
around the unit.
· Be sure ventilation holes are not covered.
· Prevent extra heat from reaching the unit. Never put
the CDR510 in direct sunlight or near a heat
source.
· Do not expose the CDR510 to electrostatic dis-
charges.
· Do not place heavy objects on the unit.
· Be sure the CDR510 is placed on a vibration-free
surface.
Precautions - connection
· Unplug the power cord from the AC outlet or turn off
the POWER switch before making any connection.
· Connect one cable at a time observing the 'input'
and 'output' labeling. This will avoid any cross
connections between channels and signal inputs
and outputs.
· Insert plugs securely. An incomplete connection
may result in noise.
· Before connecting other audio or video equipment
to the CDR510, please read their owner's manuals.
CE marking
English
This product is in conformity with the EMC directive and low-voltage directive.
Français
Cet appareil est cnforme á la directive EMC et á la de directive sur les basses tensions.
Deutsch
Dieses Greät entspricht den EMC-Richtlinien und den Richtlinien für Niederspannungsgeräte.
Nederlands
Dit apparaat voldoet aan de EMC-richtlijnene en de richtlijnen vooor apparatuur met laag voltage.
Italiano
Quest' unitá è conforme alle diretive EMC ed alla direttiva sulle basse tensioni.
Português
Esta unidade está em conformidade com as directivas EMC e as directivas de baixa voltagem.
Español
Esta unidad estáde acuerdo con las normas EMC y las relacionadas con baja tensión.
MARANTZ EUROPE B.V.
5600 EINDHOVEN
THE NETHERLANDS
SI DICHIARA CHE L'APPARECCHIO SINTO-AMPLIFACATORE SR-39 RISPONDE ALLE PRESCRIZIONI DELL'ART.
2 COMMA 1 DEL D.M. 28 AGOSTO 1995 N° 548.
FATTO A EINDHOVEN, IL 1/1/1997.
"Este aparato lleva elementos antiparasitarios necesarios para cumplir con ls limites que se estableren en el Anexo
V del Reglamento sobre Pertubaciones Radioelectricas e Interferencias aprobado en el Real Decreto 138/1989.
(B.O.E. de 9 Febrero 1989)."
WARNINGS FOR LASER RADIATION
CAUTION: INVISIBLE LASER RADIATION WHEN OPEN, DO NOT STARE INTO BEAM.
DANGER:
INVISIBLE LASER RADIATION WHEN OPENT, AVOID DIRECT EXPOSURE TO BEAM.
VAROI:
AVATTAESSA JA SUOJALUKITUS OHITETTAESSA OLET ALTTINANAYMÄTTÖMÄALLE
LASERSÄTEILYLLE. ÄLÄ KATSO SÄTEESEEN.
VARNING! OSYNLIGH LASERSTÄLNING NÄR DENNA DEL ÄR ÖPPNAD OCH SPÄRREN ÄR URKOPPLAD.
BETRAKTA EJ STRALEN.
- 4 -
- 5 -
Important Safety Instructions
READ BEFORE OPERATING EQUIPMENT
This product was designed and manufactured to meet strict quality
and safety standards. There are, however, some installation and
operation precautions which you should be particularly aware of.
1.
Read Instructions All the safety and operating instructions
should be read before the product is operated.
2.
Retain Instructions The safety and operating instructions
should be retained for future reference.
3.
Heed Warnings All warnings on the product and in the
operating instructions should be adhered to.
4.
Follow Instructions All operating and use instructions should
be followed.
5.
Cleaning Unplug this product from the wall outlet before
cleaning. Do not use liquid or aerosol cleaners. Use a damp
cloth for cleaning.
6.
Attachments Do not use attachments not recommended by
the product manufacturer as they may cause hazards.
7.
Water and Moisture Do not use this product near waterfor
example, near a bath tub, wash bowl, kitchen sink, laundry tub,
swimming pool, in a wet basement, and the like.
8.
Accessories Do not place this product on an unstable cart,
stand, tripod, bracket, or table. The product may fall, causing
serious injury to a child or adult, and serious damage to the
product. Use only with a cart, stand, tripod, bracket or table
recommended by the manufacturer, or sold with the product.
Any mounting of the product should follow the manufacturer's
instructions, and should use a mounting accessory
recommended by the manufacturer.
9.
A product and cart combination
should be moved with care. Quick
stops,
excessive
force,
and
uneven surfaces may cause the
product and cart combination to
overturn.
10.
Ventilation Slots and openings in
the cabinet are provided for
ventilation and to ensure reliable
operation of the product and to
protect it from overheating. These
openings must not be blocked or covered. The openings should
never be blocked by placing the product on a bed, sofa, rug, or
other similar surface. This product should not be placed in a
built-in installation such as a bookcase or rack unless proper
ventilation is provided or the manufacturer's instructions have
been adhered to.
11.
Power Sources This product should be operated only from the
type of power source indicated on the marking label. If you are
not sure of the type of power supply to your home, consult your
product dealer or local power company. For products intended
to operate from battery power or other sources, refer to the
operating instructions.
12.
Power Cord Protection Power supply cords should be routed
so that they are not likely to be walked on or pinched by items
placed upon or against them, paying particular attention to
cords at plugs, convenience receptacles, and the point where
they exit from the product.
the service technician has used a replacement plug specified
by the manufacturer that has the same overload protection as
the original plug.
15.
Outdoor Antenna Grounding If an outside antenna or cable
system is connected to the product, be sure the antenna or
cable system is grounded so as to provide some protection
against voltage surges and built-up static charges. Article 810
of the National Electrical Code, ANSI/NFPA 70, provides
information with regard to proper grounding of the mast and
supporting structure, grounding of the lead-in wire to an
antenna discharge unit, size of grounding conductors, location
of antenna-discharge unit, connection to grounding electrodes,
and requirements for the grounding electrode. See Figure 1.
16.
Lightning Lightning Unplug the unit from the wall outlet and
disconnect the antenna or cable system for added protection
during a lightning storm or when it is left unattended and
unused for long periods of time. This will prevent damage to the
product due to lightning and power line surges.
17.
Power Lines An outside antenna system should not be
located in the vicinity of overhead power lines or other electric
light or power circuits, or where it can fall into such power lines
or circuits. When installing an outside antenna system, extreme
care should be taken to keep from touching such power lines or
circuits as contact with them might be fatal.
18.
Overloading Do not overload wall outlets, extension cords, or
integral convenience receptacles as this can result in a risk of
fire or electric shock.
19.
Object and Liquid Entry Never push objects of any kind into
this product through openings as they may touch dangerous
voltage points or short-out parts that could result in a fire or
electric shock. Never spill liquid of any kind on the product.
20.
Servicing Do not attempt to service this product yourself as
opening or removing covers may expose you to dangerous
voltage or other hazards. Refer all servicing to qualified service
personnel.
21.
Damage Requiring Service Unplug this product from the wall
outlet and refer servicing to qualified service personnel under
the following conditions:
a.
When the power supply cord or plug is damaged.
b.
If liquid has been spilled, or objects have fallen into the product.
c.
If the product has been exposed to rain or water.
d.
If the product does not operate normally by following the
operating instructions. Adjust only those controls that are
covered by the operating instructions, as an improper
adjustment of other controls may result in damage and will often
require extensive work by a qualified technician to restore the
product to its normal operation.
e.
If the product has been dropped or damaged in any way, and
f.
When the product exhibits a distinct change in performance
this indicates a need for service.
22.
Replacement Parts When replacement parts are required, be
sure the service technician has used replacement parts
specified by the manufacturer or have the same characteristics
as the original part. Unauthorized substitutions may result in
fire, electric shock, or other hazards.
23.
Safety Check Upon completion of any service or repairs to
this product, ask the service technician to perform safety
checks to determine that the product is in proper operating
condition.
24.
Wall or Ceiling Mounting The product should be mounted to a
wall or ceiling only as recommended by the manufacturer.
25.
Heat The product should be situated away from heat sources
such as radiators, heat registers, stoves, or other products
(including amplifiers) that produce heat.
13.
Grounding or Polarization
This product may be equipped
with a grounded polarized
alternating-current line plug (a
plug having one blade wider
than the other and a ground
prong). This plug will fit into the
power outlet only one way.
This is a safety feature. If you
are unable to insert the plug
fully into the outlet,contact
your electrician to replace your obsolete outlet. Do not defeat
the safety purpose of the polarized plug.
14.
Protective Attachment Plug The product is equipped with an
attachment plug having overload protection. This is a safety
feature. See Instruction Manual for replacement or resetting of
protective device. If replacement of the plug is required, be sure