INSTRUCTION MANUAL
© B62-1175-00 (K)
09 08 07 06 05 04 03 02 01 00
VHF FM TRANSCEIVER
KENWOOD CORPORATION
TK-190
x
GOVERNMENT LAW PROHIBITS THE OPERATION OF
UNLICENSED RADIO TRANSMITTERS WITHIN THE
TERRITORIES UNDER GOVERNMENT CONTROL.
x
ILLEGAL OPERATION IS PUNISHABLE BY FINE OR
IMPRISONMENT OR BOTH.
x
REFER SERVICE TO QUALIFIED TECHNICIANS ONLY.
x
DO NOT OPERATE YOUR TRANSCEIVER IN EXPLOSIVE
ATMOSPHERES (GASES, DUST, FUMES, ETC.).
x
TURN OFF YOUR TRANSCEIVER WHILE TAKING ON FUEL,
OR WHILE PARKED IN GASOLINE SERVICE STATIONS.
THANK YOU
We are grateful you chose KENWOOD for your land
mobile radio applications. We believe this easy-to-use
transceiver will provide dependable communications to
keep personnel operating at peak efficiency.
KENWOOD transceivers incorporate the latest in
advanced technology. As a result, we feel strongly that
you will be pleased with the quality and features of this
product.
NOTICES TO THE USER
SAFETY: It is important that the operator is aware of
and understands hazards common to the operation of
any transceiver.
PERFORMANCE: The performance of low band
portable tranceivers depend on your operating practices
and the environmental conditions. To obtain the best
performance from your transceiver, use the transceiver
only with a KRA-21 antenna. Refer to the KRA-21
instruction manual for important information concerning
the use of the antenna.
i
One or more of the following statements may be
applicable:
ATTENTION (U.S.A. Only):
The RBRC Recycle seal found on KENWOOD
nickel-cadmium (Ni-Cd) battery packs indicates
KENWOOD's voluntary participation in an industry
program to collect and recycle Ni-Cd batteries after
their operating life has expired. The RBRC program
is an alternative to disposing Ni-Cd batteries with
your regular refuse or in municipal waste streams,
which is illegal in some areas.
For information on Ni-Cd battery recycling in your area, call (toll free)
1-800-8-BATTERY (1-800-822-8837).
KENWOOD's involvement in this program is part of our commitment
to preserve our environment and conserve our natural resources.
FCC WARNING
This equipment generates or uses radio frequency energy. Changes
or modifications to this equipment may cause harmful interference
unless the modifications are expressly approved in the instruction
manual. The user could lose the authority to operate this equipment
if an unauthorized change or modification is made.
INFORMATION TO THE DIGITAL DEVICE USER REQUIRED BY
THE FCC
This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation.
This equipment generates, uses and can generate radio frequency
energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that the interference will not occur in a
particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
·
Reorient or relocate the receiving antenna.
·
Increase the separation between the equipment and receiver.
·
Connect the equipment to an outlet on a circuit different from that
to which the receiver is connected.
·
Consult the dealer for technical assistance.
ii
CONTENTS
UNPACKING AND CHECKING EQUIPMENT .......................... 1
Supplied Accessories ............................................. 1
PREPARATION .......................................................... 2
Installing/ Removing the Optional NiCd Battery Pack .......... 2
Installing the Optional Antenna .................................. 3
Installing the Belt Clip ............................................ 3
Installing the Cap over the Universal Connector .............. 4
Installing the Optional KMC-25 Speaker/ Microphone .......... 4
GETTING ACQUAINTED ................................................ 5
Display ............................................................. 8
PROGRAMMABLE AUXILIARY FUNCTIONS ......................... 9
Function Descriptions ........................................... 10
OPERATING BASICS ................................................. 14
Switching Power ON/OFF ....................................... 14
Adjusting the Volume ........................................... 14
Selecting a Channel ............................................. 14
Making a Call .................................................... 15
Adjusting the Squelch........................................... 15
SCANNING ............................................................ 16
Priority Scan ..................................................... 17
Revert Channel .................................................. 18
SIGNALLING .......................................................... 19
2-Tone Signalling................................................ 19
DTMF Signalling ................................................. 20
Dead Beat Disable (DBD)....................................... 21
PTT ID ............................................................. 21
QUIET TALK (QT) AND DIGITAL QUIET TALK (DQT) .............. 22
AUXILIARY FEATURES ............................................... 23
Key Lock .......................................................... 23
Time-out Timer (TOT) ........................................... 24
Busy Channel Lockout (BCL) ................................... 24
Voice Scrambler ................................................. 25
AUDIBLE USER FEEDBACK TONES ................................. 26