Before you begin:
WARNING
MOUNTING BRACKET FOR LZH-70W OVERHEAD CONSOLE
SK-70MB
INSTALLATION
MANUAL
KENWOOD USA CORPORATION
· To minimize the risk of improper installation,
Kenwood recommends that the installation
of this product be performed by an MECP-
Certified professional installer. Improper
installation may cause damage to the
vehicle or injury to the driver and occupants.
· Installation must be performed according
to
the
product
installation
manual.
Kenwood is not responsible for damages or
injuries resulting from installation not
performed strictly in accordance with the
procedures described in the manual.
· This product is designed only to be used
with the LZH-70W overhead console.
· Use only new, unused and properly-sized
fasteners to install this product. Do not use
previously-installed or worn fasteners.
· No modifications to the product or
mounting hardware are permitted.
· The monitor screen that attaches to this
product must not be visible to the driver.
Viewing by the driver while operating the
vehicle will create an unsafe condition.
· This product must not obstruct the driver's
rear view when installed or used.
· It is the responsibility of the purchaser and
installer to comply with all applicable laws
and regulations governing the installation
and use of this product.
· Kenwood disclaims all liability for any
property damage or personal injury that
may result from improper or unintended
installation or use of this product.
Step 2: Connecting the bracket halves together
Step 3: Attaching the bracket to the crossmembers
www.kenwoodusa.com
www.kenwoodusa.com/inquiry
1-800-KENWOOD
©2003 Kenwood USA Corporation. All Rights Reserved.
Main Office
P.O. Box 22745
Long Beach, CA 90801-5745
Canada Office
6070 Kestrel Road
Mississaugua, Ontario L5T 1S8
Installation procedure
Note: Before installing the SK-70MB, it will be
necessary to remove the vehicle's headliner. Refer to
the LZH-70W Installation Manual for more complete
installation information.
1. Fit the mounting bracket halves together so they span
the distance between the vehicle roof crossmembers
that are directly fore and aft of the console mounting
location.
2. Use a marking pen to mark the top bracket half through
2 of the pilot holes on each angled side of the bottom
bracket half. Use 4 of the supplied ½" self-tapping
screws to connect the bracket halves together.
3. Using 4 screws on each end, attach the bracket to the
crossmembers on the vehicle's centerline
· B
Bee ssuurree nnoott ttoo ddrriillll tthhrroouugghh tthhee vveehhiiccllee''ss rrooooff
(Measure the distance from the bracket's surface to
the roof; measure and mark the drill bit with masking
tape to prevent the bit from touching the roof when
drilling the holes)
· If the roof crossmembers are too narrow for you to use
4 screws on each end of the bracket, use 2 screws on
each end
Box contents
Unpack your SK-70MB carefully and make sure that everything listed here is present. If anything is missing,
notify your dealer immediately. If your SK-70MB was shipped to you directly, notify your shipper immediately.
2 x Bracket Halves
1 x Hardware Package