KVT-735DVD
KVT-745DVD
KVT-765DVD
MONITOR WITH DVD RECEIVER
INSTALLATION MANUAL
DVD
DVD
DVD
© PRINTED IN JAPAN B54-4434-00/00 (M)(AI)
English
2 English
Before Installation
..........1
..........2
..........1
..........1
..........1
..........1
1
..........4
7
..........4
-
..........4
=
2
..........4
8
..........2
9
..........2
0
3
4
5
6
Accessories
English 3
1. To prevent a short circuit, remove the key from the
ignition and disconnect the - battery.
2. Make the proper input and output wire connections for
each unit.
3. Connect the speaker wires of the wiring harness.
4. Connect the wiring harness wires in the following order:
ground, battery, ignition.
5. Connect the wiring harness connector to the unit.
6. Install the unit in your car.
7. Reconnect the - battery.
8. Press the reset button.
If you connect the ignition wire (red) and the battery wire
(yellow) to the car chassis (ground), you may cause a short
circuit, that in turn may start a fire. Always connect those
wires to the power source running through the fuse box.
· If your car's ignition does not have an ACC position,
connect the ignition wires to a power source that can be
turned on and off with the ignition key. If you connect the
ignition wire to a power source with a constant voltage
supply, as with battery wires, the battery may die.
· If the console has a lid, make sure to install the unit so
that the faceplate will not hit the lid when closing and
opening.
· If the fuse blows, first make sure the wires aren't
touching to cause a short circuit, then replace the old
fuse with one with the same rating.
· Insulate unconnected wires with vinyl tape or other
similar material. To prevent a short circuit, do not remove
the caps on the ends of the unconnected wires or the
terminals.
· Connect the speaker wires correctly to the terminals to
which they correspond. The unit may be damaged or fail
to work if you share the - wires or ground them to any
metal part in the car.
· When only two speakers are being connected to the
system, connect the connectors either to both the front
output terminals or to both the rear output terminals (do
not mix front and rear). For example, if you connect the
+ connector of the left speaker to a front output
terminal, do not connect the - connector to a rear
output terminal.
· After the unit is installed, check whether the brake
lamps, blinkers, wipers, etc. on the car are working
properly.
· Mount the unit so that the mounting angle is 30° or less.
2CAUTION
2WARNING
Installation Procedure
English
Connection
4 English
B
C
B
C
( 5A )
PRK SW
A
+
+
B
C
A
Ground wire (Black) - (To car chassis)
Battery wire (Yellow)
Ignition wire (Red)
ACC
Ignition key switch
Battery
Car fuse
box
(Main fuse)
Connect to the vehicle's parking brake detection switch
harness using the supplied relay connector.
For the sake of safety, be sure to connect the parking sensor.
2 CAUTION
Do not connect.
Monitor unit
Wiring harness
(Accessory 3)
Car fuse box
Accessory 4
Accessory 2
FM/AM antenna input
Battery wire (Yellow)
Dimmer control wire (Orange/White)
To car light control switch
Ground wire (Black) - (To car chassis)
Motor antenna control wire
(Blue)
Power control wire
(Blue/White)
External amplifier control wire
(Pink/Black)
Depending on what antenna you are using,
connect either to the control terminal of the motor
antenna, or to the power terminal for the booster
amplifier of the film-type antenna.
When using the optional power amplifier,
connect to its power control terminal.
To "EXT.AMP.CONT." terminal of the amplifier
having the external amp control function.
If you connect the ignition wire (red) and the battery wire (yellow) to the car chassis (ground),
you may cause a short circuit, that in turn may start a fire. Always connect those wires to the
power source running through the fuse box.
2WARNING
English 5
MUTE
ANT. CONT
P CONT
EXT.CONT
+
+
+
+
ILLUMI
( 10A )
TO 5L-I/F
TO NAVIGATION I/F
TO TV TUNER I/F
PREOUT
FM/AM
ANTENNA
AVINPUT
AVOUTPUT
TOMONIT
ORI/F
POWER
Disc Changer etc.
Receiver unit (front side)
Receiver unit (rear side)
Wiring harness
(Accessory 1)
Mute wire (Brown)
White/Black
To front left speaker
To front right speaker
To rear left speaker
To rear right speaker
White
Gray/Black
Gray
Green/Black
Green
Purple/Black
Purple
Connect to the terminal that is grounded when either
the telephone rings or during conversation.
To connect the KENWOOD navigation system, consult your
navigation manual.
NOTE
Cable (included in the disc changer)