DIGITAL VIDEO
DIGITAL VIDEO
COMPACT
COMPACT
TEXT
DIGITAL AUDIO
DIGITAL AUDIO
COMPACT
COMPACT
DVD / VCD / CD PLAYER
B60-4026-00 00 J (M2,T,E) MC
98 / 8
DV-S701
KENWOOD CORPORATION
INSTRUCTION MANUAL
This player has been designed to play back the DVD software which has been encoded for specific
region areas. It cannot play back the DVD software encoded for other region areas than the region
areas for which it has been designed.
2
DV-S701 (En/E)
Operations
Other
Preparations
The marking is located on the rear panel and says that the component
uses laser beams that have been classified as Class 1. It means that
the unit is utilizing laser beams that are of a weaker class. There is no
danger of hazardous radiation outside the unit.
CLASS 1
LASER PRODUCT
The marking of products using lasers
(Except for some areas)
Factory fitted moulded mains plug
1. The mains plug contains a fuse. For replacement, use only a 13-Amp ASTA-approved (BS1362) fuse.
2. The fuse cover must be refitted when replacing the fuse in the moulded plug.
3. Do not cut off the mains plug from this equipment. If the plug fitted is not suitable for the power points in your home or the cable is too short
to reach a power point, then obtain an appropriate safety approved extension lead or adapter, or consult your dealer.
If nonetheless the mains plug is cut off, remove the fuse and dispose of the plug immediately, to avoid a possible shock hazard by inadvertent
connection to the mains supply.
IMPORTANT :
The wires in the mains lead are colouRed in accordance with the following code :
Blue
: Neutral
Brown : Live
Do not connect those leads to the earth terminal of a three - pin plug.
Before applying power
Caution : Read this section carefully to ensure safe operation.
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
Safety precautions
WARNING : TO PREVENT FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS
APPLIANCE TO RAIN OR MOISTURE.
For the United Kingdom
REQUIREMENT BY NEDERLAND GAZETTE
Batteries are supplied with this product. When
they empty, you should not throw away. Instead,
hand them in as small chemical waste.
Units are designed for operation as follows.
This unit is intended for ................................ AC 110-240 V
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR
BACK). NO USER-SERVICEABLE PARTS INSIDE, REFER SERVICING TO QUALIFIED SER-
VICE PERSONNEL.
THE LIGHTNING FLASH WITH ARROWHEAD SYMBOL, WITHIN AN EQUILATERAL TRIANGLE, IS INTENDED TO ALERT THE
USER TO THE PRESENCE OF UNINSULATED "DANGEROUS VOLTAGE" WITHIN THE PRODUCT'S ENCLOSURE THAT MAY
BE OF SUFFICIENT MAGNITUDE TO CONSTITUTE A RISK OF ELECTRIC SHOCK TO PERSONS.
THE EXCLAMATION POINT WITHIN AN EQUILATERAL TRIANGLE IS INTENDED TO ALERT THE USER TO THE PRESENCE OF
IMPORTANT OPERATING AND MAINTENANCE (SERVICING) INSTRUCTIONS IN THE LITERATURE ACCOMPANYING THE
APPLIANCE.
Caution : Read this section carefully to ensure safe operation.
Introduction
3
DV-S701 (En/E)
Operations
Other
Preparations
Unpacking
Unpack the unit carefully and make sure that all accessories are put aside so they will not be lost.
Examine the unit for any possibility of shipping damage. If your unit is damaged or fails to operate, notify your dealer
immediately. If your unit was shipped to you directly, notify the shipping company without delay. Only the consignee (the
person or company receiving the unit) can file a claim against the carrier for shipping damage.
We recommend that you retain the original carton and packing materials for use should you transport or ship the unit in the
future.
Keep this manual handy for future reference.
Accessories
Audio cord (Red, White) ...... (3)
Remote control unit ............. (1)
Batteries (R6/AA) ................. (2)
Digital cord (Orange) ......... (1)
Video cord (Yellow) .............. (1)
Introduction
System control cord ......... (1)
4
DV-S701 (En/E)
Operations
Other
Preparations
6. Temperature The appliance may not function properly if
used at extremely low, or freezing temperatures. The ideal
ambient temperature is above +5°C (41°F).
7. Heat The appliance should be situated away from heat
sources such as radiators, heat registers, stoves, or other
appliances (including amplifiers) that produce heat.
8. Electric shock Care should be taken so that objects do not
fall and liquid is not spilled into the enclosure through open-
ings. If a metal objects, such as a hair pin or a needle, comes
into contact with the inside of this appliance, a dangerous
electric shock may result. For families with children, never
permit children to put anything, especially metal, inside this
appliance.
9. Enclosure removal Never remove the enclosure. If the
internal parts are touched accidentally, a serious electric
shock might occur.
10. Magnetic fields Keep the appliance away from sources of
magnetic fields such as TV sets, speaker systems, radios,
motorized toys or magnetized objects.
11. Cleaning Unplug this appliance from the wall outlet before
cleaning. Do not use volatile solvents such as alcohol, paint
thinner, gasoline, or benzine, etc. to clean the cabinet. Use
a clean dry cloth.
12. Accessories Do not place this appliance on an unstable cart,
stand, tripod, bracket, or table. The appliance may fall, caus-
ing serious injury to a child or adult, and serious damage to the
appliance. Use only with a cart, stand, tripod, bracket, or table
recommended by the manufacturer, or sold with the appli-
ance. Any mounting of the appliance should follow the
manufacturer's instructions, and should use a mounting
accessory recommended by the manufacturer. An appliance
and cart combination should be moved with care. Quick
stops, excessive force, and uneven surfaces may cause the
appliance and cart combination to overturn.
Please read all of the safety and operating instructions before
operating this appliance. Adhere to all warnings on the appliance
and in the instruction manual. Follow all the safety and operating
instructions. These safety and operating instructions should be
retained for future reference.
1. Power sources The appliance should be connected to a
power supply only of the type described in the instruction
manual or as marked on the appliance. If you are not sure of
the type of power supply to your home, consult your appli-
ance dealer or local power company. For appliances intended
to operate from battery power, or other sources, refer to the
instruction manual.
2. Power-cord protection Power-supply cords should be
routed so that they are not likely to be walked on or pinched
by items placed upon or against them, pay particular attention
to cords at plugs, convenience receptacles, and the point
where they exit from the appliance.
3.
CAUTION Polarization This appliance may be
equipped with a polarized alternating-current line plug (a plug
having one blade wider than the other). This plug will fit into
the power outlet only one way. This is a safety feature. If you
are unable to insert the plug fully into the outlet, try reversing
the plug. If the plug should still fail to fit, contact your
electrician to replace your obsolete outlet. Do not defeat the
safety purpose of the polarized plug.
4. Ventilation Slots and openings in the cabinet are provided
for ventilation and to ensure reliable operation of the appli-
ance and to protect it from overheating, and these openings
must not be blocked or covered. The appliance should be
situated so that its location or position does not interfere with
its proper ventilation.
To maintain good ventilation, do not put records or a table-
cloth on the appliance. Place the appliance at least 10 cm
away from the walls.
Do not use the appliance on a bed, sofa, rug or similar surface
that may block the ventilation openings. This appliance should
not be placed in a built-in installation such as a bookcase or
rack unless proper ventilation is provided or the manufacturer's
instructions have been adhered to.
5. Water and moisture The appliance should not be used near
water - for example, near a bathtub, washbowl, kitchen sink,
laundry tub, in a wet basement, or near a swimming pool, etc.
Never pull or
stretch the cord.
IMPORTANT SAFEGUARDS
Caution : Read this page carefully to ensure safe operation.
5
DV-S701 (En/E)
Operations
Other
Preparations
18. Power lines An outside antenna system should not be
located in the vicinity of overhead power lines or other electric
light or power circuits, or where it can fall into such power
lines or circuits. When installing an outside antenna system,
extreme care should be taken to keep from touching such
power lines or circuits as contact with them might be fatal.
19. AC outlets Do not connect other audio equipment with a
power consumption larger than that specified to the AC outlet
on the rear panel. Never connect other electrical appliances,
such as an iron or toaster, to it to prevent fire or electric shock.
20. Overloading Do not overload wall outlets, extension cords,
or integral convenience receptacles as this can result in a risk
of fire or electric shock.
21. Attachment Do not use attachments not recommended by
the appliance manufacturer as they may cause hazards.
22. Replacement parts When replacement parts are required,
be sure the service technician has used replacement parts
specified by the manufacturer or have the same characteris-
tics as the original parts. Unauthorized substitutions may
result in fire, electric shock, or other hazards.
23. Safety check Upon completion of any service or repairs to
this appliance, ask the service technician to perform safety
checks to determine that the appliance is in proper operating
condition.
13. Lightning For added protection for this appliance during a
lightning storm, or when it is left unattended and unused for
long periods of time, unplug it from the wall outlet and
disconnect the antenna or cable system. This will prevent
damage to the appliance due to lightning and power-line
surges.
14. Abnormal smell If an abnormal smell or smoke is detected,
immediately turn the power OFF and unplug the appliance
from the wall outlet. Contact your dealer or nearest service
center.
15. Damage requiring service The appliance should be ser-
viced by qualified service personnel when:
A. The power-supply cord or the plug has been damaged.
B. Objects have fallen, or liquid has been spilled into the
appliance.
C. The appliance has been exposed to rain or water.
D. The appliance does not appear to operate normally by
following the instruction manual. Adjust only those controls
that are covered by the instruction manual as an improper
adjustment of other controls may result in damage and will
often require extensive work by a qualified technician to
restore the appliance to its normal operation.
E. The appliance has been dropped, or the enclosure dam-
aged.
F. The appliance exhibits a marked change in performance.
16. Servicing The user should not attempt to service the
appliance beyond that described in the instruction manual. All
other servicing should be referred to qualified service person-
nel.
17. Outdoor antenna grounding If an outside antenna is
connected to the appliance, be sure the antenna system is
grounded so as to provide some protection against voltage
surges and built up static charges. Article 810 of the National
Electrical Code
ANSI/NFPA 70, provides information with
respect to proper grounding of the mast and supporting
structure, grounding of the lead-in wire to an antenna dis-
charge unit, size of grounding conductors, location of antenna
discharge unit, connection to grounding electrodes, and
requirements for the grounding electrode. See Figure.
Notes
Notes
EXAMPLE OF ANTENNA GROUNDING AS PER
NATIONAL ELECTRICAL CODE
ANTENNA
DISCHARGE UNIT
(NEC SECTION 810-20)
ANTENNA
LEAD IN WIRE
ELECTRIC
SERVICE
EQUIPMENT
NEC NATIONAL ELECTRICAL CODE
1. Item 3 is not required except for grounded or polarized equipment.
2. Item 17 and 18 are not required except for units provided with antenna
terminals.
3. Item 17 complies with UL in the U.S.A.
GROUND
CLAMPS
POWER SERVICE GROUNDING
ELECTRODE SYSTEM
(NEC ART 250, PART H)
GROUNDING CONDUCTORS
(NEC SECTION 810-21)
GROUND CLAMP
POWER OFF!
IMPORTANT SAFEGUARDS