INSTRUCTIONS
XM-448BK
For Customer Use:
Enter below the Model No. and Serial
No. which are located either on the rear,
bottom or side of the cabinet. Retain this
information for future reference.
Model No.
Serial No.
LVT0222-001A
[J]
MINI DISC RECORDER
1¡
4
¢
0
8
¶3
7
RM-SXM448J REMOTE CONTROL
1
2
3
4
5
67
89
10
+10
POWER
PROGRAM
CANCEL
RANDOM
REPEAT
ON/OFF
TRACK MARKING
DIMMER
MODE
XM-448BK[J].COVER
99.1.28, 3:21 PM
1
CAUTION:
TO REDUCE THE RISK OF ELECTRIC SHOCK.
DO NOT REMOVE COVER (OR BACK)
NO USER SERVICEABLE PARTS INSIDE.
REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
RISK OF ELECTRIC SHOCK
DO NOT OPEN
The lightning flash with arrowhead symbol,
within an equilateral triangle is intended to
alert the user to the presence of uninsulated
"dangerous voltage" within the product's
enclosure
that
may
be
of
sufficient
magnitude to constitute a risk of electric
shock to persons.
The exclamation point within an equilateral
triangle is intended to alert the user to the
presence
of
important
operating
and
maintenance (servicing) instructions in the
literature accompanying the appliance.
CAUTION
WARNING: TO REDUCE THE RISK OF FIRE
OR ELECTRIC SHOCK, DO NOT EXPOSE
THIS APPLIANCE TO RAIN OR MOISTURE.
For U.S.A.
This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the
instructions,
may
cause
harmful
interference
to
radio
communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the
following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
G-1
Warnings, Cautions and Others
CAUTION
To reduce the risk of electrical shocks, fire, etc.:
1.
Do not remove screws, covers or cabinet.
2.
Do not expose this appliance to rain or moisture.
1.
CLASS 1 LASER PRODUCT
2.
DANGER: Invisible laser radiation when open and
interlock failed or defeated. Avoid direct exposure to
beam.
3.
CAUTION: Do not open the top cover. There are no user
serviceable parts inside the Unit; leave all servicing to
qualified service personnel.
Caution POWER switch!
Disconnect the mains plug to shut the power off completely.
The POWER switch in any position does not disconnect the
mains line. The power can be remote controlled.
XM-448BK[J].Safety
99.1.28, 3:21 PM
1
1
Welcome !
We would like to thank you for purchasing one of our JVC products. Before connecting
this unit to the wall outlet, please read the instructions carefully to ensure that you obtain
the best possible performance. If you have any questions, please consult your JVC dealer.
Important cautions
Installation of the Unit
·
Select a place which is level, dry and neither too hot nor too cold (between 5°C and
35°C or 41°F and 95°F).
·
Leave sufficient distance between the unit and a TV set.
·
Be sure to place the unit in a location with good ventilation.
·
Do not use the unit in a place subject to vibrations.
·
Do not place the unit on a carpet.
·
Do not place the unit on top of another heat-generating piece of equipment.
Power cord
·
Do not handle the power cord with wet hands!
·
When unplugging the unit from the wall outlet, always pull the plug, not the power
cord.
Malfunctions, etc.
·
There are no user serviceable parts inside. If anything goes wrong, turn off the power
immediately. If the same problem occurs again when the power is turned on once more,
turn off the power again, unplug the power cord and consult your dealer.
·
Do not insert any metallic object into the unit.
For safe use, observe the
following
Avoid moisture, water and dust
Do not set your machine in moist or dusty places.
Avoid high temperatures
Do not expose your machine to direct sunlight or set near a heating device.
Do not block the vents
Poor-ventilation may damage your machine. So do not block the vents or put the unit
in a poorly ventilated place.
When you're away
When away on travel or otherwise for an extended period of time, turn off the power
and pull the plug from the electrical socket.
Do not insert any foreign matter into the unit
Do not insert wires, hairpins, coins, etc. into your unit.
Care for the cabinet
When cleaning your unit, use a soft cloth and follow the relevant instructions on the use
of chemically-coated cloths. Avoid applying benzene, thinner or other organic solvents
and disinfectants. This may cause deformation or discoloring.
If water gets inside the unit
Turn off the power and pull the plug from the electrical socket, then call the store where
you made your purchase. Using the unit in this state may cause a fire or electrical
shock.
US and foreign patents licensed from Dolby Laboratories Licensing Corporation.
EN01-16.XM-448BK[J]/f
99.1.28, 3:24 PM
1
2
Table of Contents
Welcome ! .................................................... 1
Important cautions ....................................... 1
For safe use, observe the following ............. 1
Parts Index ........................................... 3
Front panel .............................................. 3
Display .................................................... 3
Remote control unit ................................ 4
Setting up the System ........................ 5
Supplied accessories .................................... 5
Remote control batteries .............................. 5
Operating the remote control unit ................ 5
Connection ................................................... 6
Turning the Power On and Off ............ 7
Power On ..................................................... 7
Power Off ..................................................... 7
Playback ............................................... 8
Continuous playback ................................... 8
Using the display mode ............................. 10
Program playback ...................................... 10
Random playback ...................................... 12
Repeat playback ......................................... 13
Recording .......................................... 14
Recording operation .................................. 14
Editing Functions .............................. 17
MD editing functions ................................. 17
Dividing a track (DIVIDE) ........................ 19
Joining tracks (JOIN) ................................ 20
Moving a track (MOVE) ........................... 22
Erasing a track (ERASE) ........................... 23
Erasing all tracks in an MD
(ALL ERASE) ...................................... 25
Assigning the disc title and track titles ...... 26
COMPU LINK ..................................... 30
Linked Operation of the Other Optional
Components (Compu Link) .................. 30
TEXT COMPU LINK ........................... 31
Rule on Digital Copying .................... 33
SCMS (Serial Copy Management System) .. 33
About MD (Mini Disc) ........................ 34
Role of the cartridge .................................. 34
Two disc types ........................................... 34
ATRAC (Adaptive TRansform
Acoustic Coding) .................................. 35
Sound skip guard memory ......................... 35
UTOC (User Table Of Contents) ............... 35
Handling MDs .................................... 36
MD Messages .................................... 37
MD Restrictions ................................. 38
Troubleshooting ................................ 39
Specifications ..................... Back cover
EN01-16.XM-448BK[J]/f
99.1.28, 3:24 PM
2
3
Parts Index
Become familiar with the buttons and controls before use. Refer to the pages in parentheses for details.
Front panel --------------------------------------------------------
1 PHONES jack (9)
2 PHONES LEVEL control (9)
3 DISPLAY/CHARACTER button
(10, 26)
4 INPUT SELECTOR button (15)
5 Display
6 Jog dial (4, ¢/REC
LEVEL) (9, 16)
7 1, ¡ buttons (9)
8 6 PLAY/PAUSE button (8, 9)
9 7 STOP/CANCEL button
(8, 11, 19, 27)
p ¶ REC PAUSE button (14)
q ENTER button (20, 27)
w SET button (11, 19, 26)
e EDIT button (19)
r TITLE button (26)
Display
------------------------------------------------------------
1 Level indicators and OVER indicator (16)
2 TOC indicator (20)
3 REC indicator (14)
4 Play/Pause indicators (3 (Play), 8 (Pause)) (8, 9, 14)
5 MD editing mode indicators (19 25)
(DIVIDE, JOIN, MOVE, ERASE, ALL ERASE)
6 Repeat mode indicators (13)
(REPEAT ALL, REPEAT 1)
t 0 (Eject) button (8)
y MD insertion slot (8)
u Disc indicator (7, 14)
i REPEAT button (13)
o PLAY MODE button (10, 12)
; Remote sensor (5)
a POWER button (7)
s STANDBY indicator (7)
7 Music calendar (19)
8 Play mode indicators (10, 12)
(PROGRAM, RANDOM)
9 Character display (11 digits) (26)
p MD indicator (7)
q Input mode indicators (15)
(DIGITAL 1, DIGITAL 2)
w Sampling frequency indicators (15)
(32 kHz, 44.1 kHz, 48 kHz)
1
wq
p
9
8
24
35
6
7
s
1
a ;
oi
uy
tr ewq p 9 8
24
35
6
7
DIGITAL 12
MD
32kHz 44.1kHz 48kHz
TOC
MD EDIT
DIVIDE
JOIN
MOVE
ALL ERASE
PROGRAM
RANDOM
REPEAT
ALL 1
1
6
11
16
2
7
12
17
3
8
13
18
4
9
14
19
5
10
15
20
L
40 30 20 15 10 6 3 0 dB
R
REC
REC
OVER
EN01-16.XM-448BK[J]/f
99.1.28, 3:25 PM
3