JVC KD-G200UJ - Owner's Manual Immediate Download

GET0182-001A

[J]

INSTRUCTIONS

MANUAL DE INSTRUCCIONES

MANUEL D'INSTRUCTIONS

CD RECEIVER

KD-AR200/KD-G200

ENGLISH

ESP

FRAN

AIS

For installation and connections, refer to the separate manual.

Para la instalación y las conexiones, refiérase al manual separado.

Pour l'installation et les raccordements, se référer au manuel séparé.

RECEPTEUR CD

KD-AR200/KD-G200

RECEPTOR CON CD

KD-AR200/KD-G200

For customer Use:

Enter below the Model No. and

Serial No. which are located on

the top or bottom of the

cabinet. Retain this information

for future reference.

Model No.

Serial No.

· This unit is equipped with the display demonstration. To cancel it, see page 8.

· Esta unidad está equipada con demostración en la pantalla. Para cancelarla, consulte la página 8.

· Cet appareil est équipé d'une fonction de démonstration des affichages. Pour l'annuler, référez-

vous à la page 8.

Cover001AKD-AR200[J]f.p65

9/30/03, 5:20 PM

ENGLISH

INFORMATION (For U.S.A.)

This equipment has been tested and found to comply with the limits for a Class B digital

device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable

protection against harmful interference in a residential installation. This equipment generates,

uses, and can radiate radio frequency energy and, if not installed and used in accordance with

the instructions, may cause harmful interference to radio communications. However, there

is no guarantee that interference will not occur in a particular installation. If this equipment

does cause harmful interference to radio or television reception, which can be determined by

turning the equipment off and on, the user is encouraged to try to correct the interference by one

or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to which the receiver is

connected.

Consult the dealer or an experienced radio/TV technician for help.

How to reset your unit

While holding SEL (select), press

(standby/on attenuator) for more than 2 seconds.

This will reset the built-in microcomputer.

Notes:

· Your preset adjustments--such as preset channels or sound adjustments--will also be erased.

· If a CD is in the unit, it will eject when you reset the unit. Be careful not to drop the CD.

SEL (select)

(standby/on attenuator)

IMPORTANT FOR LASER PRODUCTS

1. CLASS 1 LASER PRODUCT

2. CAUTION: Do not open the top cover. There are no user serviceable parts inside the unit; leave all

servicing to qualified service personnel.

3. CAUTION: Visible and invisible laser radiation when open and interlock failed or defeated. Avoid

direct exposure to beam.

EN02-03KD-AR200[J]f.p65

9/26/03, 7:53 PM

ENGLISH

CONTENTS

Thank you for purchasing a JVC product. Please read all instructions carefully before operation,

to ensure your complete understanding and to obtain the best possible performance from the unit.

How to reset your unit ...............................

How to use the MODE button ...................

LOCATION OF THE BUTTONS ............

Control panel .............................................

Remote controller (only for KD-AR200) ....

Preparing the remote controller

(only for KD-AR200) ...............................

BASIC OPERATIONS .......................

Turning on the power ................................

Canceling the display demonstration ........

Setting the clock ........................................

RADIO OPERATIONS ...................... 10

Listening to the radio ................................. 10

Storing stations in memory ....................... 12

Tuning in to a preset station ...................... 13

CD OPERATIONS ........................... 14

Playing a CD ............................................. 14

Locating a track or a particular portion

on a CD .................................................. 15

Selecting CD playback modes .................. 15

Prohibiting CD ejection ............................. 16

SOUND ADJUSTMENTS ................... 17

Selecting preset sound modes

(C-EQ: custom equalizer) ....................... 17

Adjusting the sound .................................. 18

OTHER MAIN FUNCTIONS ................ 19

Selecting the dimmer mode ...................... 19

Selecting the amplifier gain control ........... 19

Detaching the control panel ...................... 20

TROUBLESHOOTING ...................... 21

MAINTENANCE ............................. 22

Handling discs ........................................... 22

SPECIFICATIONS ........................... 23

BEFORE USE

*For safety....

· Do not raise the volume level too much, as this will

block outside sounds, making driving dangerous.

· Stop the car before performing any complicated

operations.

*Temperature inside the car....

If you have parked the car for a long time in hot or

cold weather, wait until the temperature in the car

becomes normal before operating the unit.

How to use the MODE button

If you press MODE, the unit goes into functions mode, then the number buttons work as different

function buttons.

Ex.: When number button 2 works as MO (monaural) button.

To use these buttons for original functions again after pressing MODE, wait for 5 seconds

without pressing any of these buttons until the functions mode is cleared.

· Pressing MODE again also clears the functions mode.

Time countdown indicator

EN02-03KD-AR200[J]f.p65

9/26/03, 7:53 PM

ENGLISH

LOCATION OF THE BUTTONS

Control panel

(standby/on attenuator) button

2 SEL (select) button

3 FM/AM button

4 CD button

5 Loading slot

6 Display window

0 (eject) button

8 Remote sensor

· Only for KD-AR200.

9 EQ (equalizer) button

5 (up) button

¡ (fast-forward) button

q Control dial

w Number buttons

e MO (monaural) button

r SSM (Strong-station Sequential Memory)

button

t RPT (repeat) button

y RND (random) button

u MODE button

i DISP (display) button

4/¢

buttons

;

(control panel release) button

(down) button

1 (reverse) button

Display window

s Tuner reception indicators--MO (monaural),

ST (stereo)

d CD indicator

f RND

(random disc) indicator

g RPT (repeat) indicator

h LOUD (loudness) indicator

j EQ (equalizer) indicator

k Sound mode (C-EQ: custom equalizer)

indicators--ROCK, CLASSIC, POPS,

HIP HOP, JAZZ, USER

l Main display

/ Source display

Volume level indicator

Display window

EN04-06KD-AR200[J]f.p65

9/26/03, 7:53 PM

ENGLISH

Remote controller

This section is only for KD-AR200.

3 Selects the preset stations while listening to

the radio.

Each time you press the button, the preset

station number increases, and the selected

station is tuned in.

4 Selects the sound mode (C-EQ: custom

equalizer).

Each time you press the button, the sound

mode (C-EQ) changes.

5 Selects the band while listening to the radio.

Each time you press the button, the band

changes.

6 Selects the source.

Each time you press the button, the source

changes.

7 Functions the same as the control dial on the

main unit.

Note: These buttons are not used for adjusting

"DEMO," "CLOCK H," "CLOCK M,"

"DIMMER," and "AMP GAIN" (see pages

8, 9 and 19).

1 · Turns on the unit if pressed when the unit is

turned off.

· Turns off the unit if pressed and held until

"SEE YOU" appears on the display.

· Drops the volume level in a moment if

pressed briefly.

Press again to resume the volume.

2 · Searches for stations while listening to the

radio.

· Fast-forwards or reverses the track if

pressed and held while listening to a CD.

· Skips to the beginning of the next track or

goes back to the beginning of the current (or

previous) tracks if pressed briefly while

listening to a CD.

RM-RK60

EN04-06KD-AR200[J]f.p65

9/26/03, 7:53 PM