INSTRUCTIONS
COMPACT COMPONENT SYSTEM
FS-Y1
Consists of CA-FSY1 and SP-FSY1
GVT0142-008A
[B]
FS-Y1[B]_f.book Page 1 Friday, April 15, 2005 7:46 PM
G-1
IMPORTANT for the U.K.
DO NOT cut off the mains plug from this equipment. If the plug
fitted is not suitable for the power points in your home or the
cable is too short to reach a power point, then obtain an
appropriate safety approved extension lead or consult your
dealer.
BE SURE to replace the fuse only with an identical approved
type, as originally fitted.
If nonetheless the mains plug is cut off ensure to remove the
fuse and dispose of the plug immediately, to avoid a possible
shock hazard by inadvertent connection to the mains supply.
If this product is not supplied fitted with a mains plug then
follow the instructions given below:
IMPORTANT:
DO NOT make any connection to the terminal which is marked
with the letter E or by the safety earth symbol or coloured
green or green-and-yellow.
The wires in the mains lead on this product are coloured in
accordance with the following code:
Blue:
Neutral
Brown:
Live
As these colours may not correspond with the coloured
markings identifying the terminals in your plug proceed as
follows:
The wire which is coloured blue must be connected to the
terminal which is marked with the letter N or coloured black.
The wire which is coloured brown must be connected to the
terminal which is marked with the letter L or coloured red.
IF IN DOUBT - CONSULT A COMPETENT ELECTRICIAN.
CAUTION
To reduce the risk of electrical shocks, fire, etc.:
1. Do not remove screws, covers or cabinet.
2. Do not expose this appliance to rain or moisture.
CAUTION -- STANDBY/ON
button!
Disconnect the mains plug to shut the power off
completely (the STANDBY lamp goes off).
The STANDBY/ON
button in any position does
not disconnect the mains line.
· When the system is on standby, the STANDBY
lamp lights red.
· When the system is turned on, the STANDBY
lamp lights green.
The power can be remote controlled.
CAUTION
· Do not block the ventilation openings or holes. (If
the ventilation openings or holes are blocked by a
newspaper or cloth, etc., the heat may not be able
to get out.)
· Do not place any naked flame sources, such as
lighted candles, on the apparatus.
· When discarding batteries, environmental
problems must be considered and local rules or
laws governing the disposal of these batteries
must be followed strictly.
· Do not expose this apparatus to rain, moisture,
dripping or splashing and that no objects filled
with liquids, such as vases, shall be placed on the
apparatus.
Warnings, cautions and others
FS-Y1[B]_f.book Page 1 Friday, April 22, 2005 1:43 PM
G-2
IMPORTANT FOR LASER PRODUCTS
1. CLASS 1 LASER PRODUCT
2. CAUTION: Do not open the top cover. There are
no user serviceable parts inside the unit; leave all
servicing to qualified service personnel.
3. CAUTION: Visible and invisible laser radiation
when open and interlock failed or defeated. Avoid
direct exposure to beam.
4. REPRODUCTION OF LABEL: CAUTION LABEL,
PLACED INSIDE THE UNIT.
Caution: Proper Ventilation
To avoid risk of electric shock and fire, and to prevent damage, locate the
apparatus as follows:
1. Front:No obstructions and open spacing.
2. Sides/Top/Back:No obstructions should be placed in the areas shown by the
dimensions below.
3. Bottom:Place on the level surface. Maintain an adequate air path for
ventilation by placing on a stand with a height of 10 cm or more.
15 cm
10 cm
1 cm
1 cm
15 cm
15 cm
Front view
Side view
CA-FSY1
CA-FSY1
Wall or obstructions
Wall or obstructions
FS-Y1[B]_f.book Page 2 Friday, April 22, 2005 1:43 PM
G-3
SAFETY INSTRUCTIONS
"SOME DOS AND DON'TS ON THE SAFE USE OF EQUIPMENT"
This equipment has been designed and manufactured to meet international safety standards but, like any electrical
equipment, care must be taken if you are to obtain the best results and safety is to be assured.
Do read the operating instructions before you attempt to use the equipment.
Do ensure that all electrical connections (including the mains plug, extension leads and interconnections between
pieces of equipment) are properly made and in accordance with the manufacturer's instructions. Switch off and
withdraw the mains plug when making or changing connections.
Do consult your dealer if you are ever in doubt about the installation, operation or safety of your equipment.
Do be careful with glass panels or doors on equipment.
DON'T continue to operate the equipment if you are in any doubt about it working normally, or if it is damaged in
any way -- switch off, withdraw the mains plug and consult your dealer.
DON'T remove any fixed cover as this may expose dangerous voltages.
DON'T leave equipment switched on when it is unattended unless it is specifically stated that it is designed for
unattended operation or has a standby mode.
Switch off using the switch on the equipment and make sure that your family know how to do this.
Special arrangements may need to be made for infirm or handicapped people.
DON'T use equipment such as personal stereos or radios so that you are distracted from the requirements of traffic
safety. It is illegal to watch television whilst driving.
DON'T listen to headphones at high volume as such use can permanently damage your hearing.
DON'T obstruct the ventilation of the equipment, for example with curtains or soft furnishings.
Overheating will cause damage and shorten the life of the equipment.
DON'T use makeshift stands and NEVER fix legs with wood screws -- to ensure complete safety always fit the
manufacturer's approved stand or legs with the fixings provided according to the instructions.
DON'T allow electrical equipment to be exposed to rain or moisture.
ABOVE ALL
--NEVER let anyone, especially children, push anything into holes, slots or any other opening in the case -- this
could result in a fatal electrical shock.;
--NEVER guess or take chances with electrical equipment of any kind -- it is better to be safe than sorry!
E43486-340B
FS-Y1[B]_f.book Page 3 Friday, April 22, 2005 1:43 PM
G-2
IMPORTANT FOR LASER PRODUCTS
1. CLASS 1 LASER PRODUCT
2. CAUTION: Do not open the top cover. There are
no user serviceable parts inside the unit; leave all
servicing to qualified service personnel.
3. CAUTION: Visible and invisible laser radiation
when open and interlock failed or defeated. Avoid
direct exposure to beam.
4. REPRODUCTION OF LABEL: CAUTION LABEL,
PLACED INSIDE THE UNIT.
Caution: Proper Ventilation
To avoid risk of electric shock and fire, and to prevent damage, locate the
apparatus as follows:
1. Front:No obstructions and open spacing.
2. Sides/Top/Back:No obstructions should be placed in the areas shown by the
dimensions below.
3. Bottom:Place on the level surface. Maintain an adequate air path for
ventilation by placing on a stand with a height of 10 cm or more.
15 cm
10 cm
1 cm
1 cm
15 cm
15 cm
Front view
Side view
CA-FSY1
CA-FSY1
Wall or obstructions
Wall or obstructions
FS-Y1[B]_f.book Page 2 Friday, April 15, 2005 7:46 PM