background image
SUPER VIDEO
COMPACT COMPONENT SYSTEM
SYSTEME DE COMPOSANTS COMPACT
FS-GD6S
--Consists of CA-FSGD6S and SP-UXGD6S
--Composé CA-FSGD6S et SP-UXGD6S
GVT0149-001A
[C]
INSTRUCTIONS
MANUEL D'INSTRUCTIONS
English
Cover[C].fm Page 1 Thursday, March 17, 2005 11:27 AM


background image
G-1
Warnings, Cautions and Others
Mises en garde, précautions et indications diverses
CAUTION
To reduce the risk of electrical shocks, fire, etc.:
1 Do not remove screws, covers or cabinet.
2 Do not expose this appliance to rain or moisture.
ATTENTION
Afin d'éviter tout risque d'électrocution, d'incendie,
etc.:
1 Ne pas enlever les vis ni les panneaux et ne pas
ouvrir le coffret de l'appareil.
2 Ne pas exposer l'appareil à la pluie ni à
l'humidité.
CAUTION:
TO REDUCE THE RISK OF ELECTRIC SHOCK,
DO NOT REMOVE COVER (OR BACK).
NO USER SERVICEABLE PARTS INSIDE.
REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
RISK OF ELECTRIC SHOCK
DO NOT OPEN
The lightning flash with arrowhead symbol,
within an equilateral triangle is intended to
alert the user to the presence of uninsulated
"dangerous voltage" within the product's
enclosure
that
may
be
of
sufficient
magnitude to constitute a risk of electric
shock to persons.
The exclamation point within an equilateral
triangle is intended to alert the user to the
presence
of
important
operating
and
maintenance (servicing) instructions in the
literature accompanying the appliance.
CAUTION
WARNING: TO REDUCE THE RISK OF FIRE
OR ELECTRIC SHOCK, DO NOT EXPOSE
THIS APPLIANCE TO RAIN OR MOISTURE.
CAUTION--
(STANDBY/ON) button!
Disconnect the mains plug to shut the power off
completely (all lamps and indications go off). The
(STANDBY/ON) button in any position does not
disconnect the mains line.
· When the unit is on standby, the STANDBY/ON lamp
lights in red.
· When the unit is turned on, the STANDBY/ON lamp lights
in green.
The power can be remote controlled.
Attention­­Touche
(STANDBY/ON:attente/
sous tension)!
Déconnectez la fiche secteur pour mettre l'appareil
complètement hors tension (tous les témoins et toutes les
indications s'éteignent). La touche
dans n'importe
quelle position ne déconnecte pas l'appareil du secteur.
· Quand l'appareil est en mode d'attente, le témoin
STANDBY/ON est allumé en rouge.
· Quand l'appareil est sous tension, le témoin STANDBY/
ON est allumé en vert.
L'alimentation ne peut pas être commandée à distance.
Safty[C].fm Page 1 Sunday, February 20, 2005 9:07 AM


background image
G-2
For U.S.A.
This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits
are designed to provide reasonable protection
against harmful interference in a residential
installation.
This equipment generates, uses and can radiate
radio frequency energy and, if not installed and
used in accordance with the instructions, may
cause harmful interference to radio
communications. However, there is no guarantee
that interference will not occur in a particular
installation. If this equipment does cause harmful
interference to radio or television reception, which
can be determined by turning the equipment off and
on, the user is encouraged to try to correct the
interference by one or more of the following
measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment
and receiver.
Connect the equipment into an outlet on a circuit
different from that to which the receiver is
connected.
Consult the dealer or an experienced radio/TV
technician for help.
For Canada/pour le Canada
CAUTION: TO PREVENT ELECTRIC SHOCK,
MATCH WIDE BLADE OF PLUG TO WIDE SLOT,
FULLY INSERT.
ATTENTION: POUR EVITER LES CHOCS
ELECTRIQUES, INTRODUIRE LA LAME LA PLUS
LARGE DE LA FICHE DANS LA BORNE
CORRESPONDANTE DE LA PRISE ET POUSSER
JUSQUAU FOND.
Note to CATV system installer:
This reminder is provided to call the CATV system
installer's attention to Section 820-40 of the NEC
which provides guidelines for proper grounding and,
in particular, specifies that the cable ground shall be
connected to the grounding system of the building,
as close to the point of cable entry as practical.
For Canada/pour le Canada
THIS DIGITAL APPARATUS DOES NOT EXCEED
THE CLASS B LIMITS FOR RADIO NOISE
EMISSIONS FROM DIGITAL APPARATUS AS SET
OUT IN THE INTERFERENCE-CAUSING
EQUIPMENT STANDARD ENTITLED "DIGITAL
APPARATUS," ICES-003 OF THE DEPARTMENT
OF COMMUNICATIONS.
CET APPAREIL NUMERIQUE RESPECTE LES
LIMITES DE BRUITS RADIOELECTRIQUES
APPLICABLES AUX APPAREILS NUMIRIQUES DE
CLASSE B PRESCRITES DANS LA NORME SUR LE
MATERIEL BROUILLEUR: "APPAREILS
NUMERIQUES", NMB-003 EDICTEE PAR LE
MINISTRE DES COMMUNICATIONS.
Safty[C].fm Page 2 Sunday, February 20, 2005 9:07 AM


background image
G-3
1 CLASS 1 LASER PRODUCT
2 CAUTION: Do not open the top cover. There are no
user serviceable parts inside the Unit; leave all
servicing to qualified service personnel.
3 CAUTION: Visible and invisible laser radiation when
open and interlock failed or defeated. Avoid direct
exposure to beam.
4 REPRODUCTION OF LABEL: CAUTION LABEL,
PLACED INSIDE UNIT.
1 PRODUIT LASER CLASSE 1
2 ATTENTION: N'ouvrez pas le couvercle supérieur. Il
n'y a aucune pièce réparable par l'utilisateur à
l'intérieur de l'appareil; confiez toute réparation à un
personnel qualifié.
3 ATTENTION: Risque de radiations laser visible et
invisible quand l'appareil est ouvert ou que le
systéme de verrouillage ne fonctionne pas ou a été
mis hors service. Évitez toute exposition directe au
rayon.
4 REPRODUCTION DE L'ÉTIQUETTE: ÉTIQUETTE
DE PRÉCAUTION PLACÉE L'INTERIEUR DE
L'APPAREIL.
Safty[C].fm Page 3 Sunday, February 20, 2005 9:07 AM


background image
1
English
Precautions
Installation
· Install the System in a location with adequate ventilation to
prevent internal heat buildup in the System.
· Install in a place which is level, dry and neither too hot nor
too cold--between 5°C and 35°C.
· Leave sufficient distance between the System and the TV.
· Keep the speakers away from the TV to avoid interference
with TV.
Power sources
· When unplugging the System from the wall outlet, always
pull on the plug, not the AC power cord.
Moisture condensation
Moisture may condense on the lenses inside the System in
the following cases:
· After starting to heat the room
· In a damp room
· If the System is brought directly from a cold to a warm
place.
Should this occur, the System may malfunction. In this case,
leave the System turned on for a few hours until the moisture
evaporates, unplug the AC power cord, then plug it in again.
Internal heat
· Make sure there is good ventilation around the unit. Poor
ventilation could overheat and damage the unit.
Others
· Should any metallic object or liquid fall into the System,
unplug the AC power cord and consult your dealer before
operating any further.
· If you are not going to operate the System for an extended
period of time, unplug the AC power cord from the wall
outlet.
If anything goes wrong, unplug the AC power cord and
consult your dealer.
Contents
Connections ..............................................................3
Display Indicators ....................................................6
Daily Operations--Playback ..................................7
Daily Operations--Sound & Other Adjustments
.....11
Adjusting the Volume ....................................................... 11
Adjusting the Sound.......................................................... 11
Creating 3-dimentional Sound Field--3D Phonic ............ 12
Presetting Automatic DVD Video Sound
Increase Level ............................................................... 12
Changing the Scanning Mode .......................................... 12
Changing the Display Brightness...................................... 13
Changing the Picture Tone................................................ 13
Adjusting the Audio Input Level ...................................... 13
Setting the Clock ............................................................... 14
Turning Off the Power Automatically .............................. 14
Unique DVD/VCD Operations .............................15
Selecting the Audio Track................................................. 15
Selecting the Subtitle Language........................................ 16
Selecting the View Angle ................................................. 16
Selecting the Browsable Still Pictures .............................. 16
Playing Back Bonus Group............................................... 16
Making Dialogues Clear--Clear Voice ............................ 17
Special Effect Playback .................................................... 17
Advanced Disc Operations....................................18
Programming the Playing Order--Program Play ............. 18
Playing at Random--Random Play .................................. 19
Playing Repeatedly ........................................................... 20
Prohibiting Disc Ejection--Child Lock ............................ 20
On-Screen Disc Operations...................................21
Timer Operations...................................................27
Setup Menu Operations ........................................29
Additional Information .........................................31
Operating JVC's TVs Using the Remote Control............. 35
Specifications .................................................................... 36
Parts Index ............................................................37
DO NOT install the System in a location near
heat sources, or in a place subject to direct
sunlight, excessive dust or vibration.
DO NOT handle the AC power cord with wet
hands.
DO NOT block the ventilation openings or
holes. If they are blocked by a newspaper or
cloth, etc., the heat may not be able to get out.
DO NOT disassemble the System since there
are no user serviceable parts inside.
Introduction
FS-GD6S[C].book Page 1 Thursday, March 17, 2005 11:13 AM