MICRO COMPONENT SYSTEM
UX-G45
--Consists of CA-UXG45 and SP-UXG45
INSTRUCTIONS
LVT1520-001A
[B]
UX-G45[B].BOOK Page 1 Friday, February 10, 2006 1:03 PM
G-1
Warnings, Cautions and Others
IMPORTANT for the U.K.
DO NOT cut off the mains plug from this equipment. If the
plug fitted is not suitable for the power points in your home
or the cable is too short to reach a power point, then obtain
an appropriate safety approved extension lead or consult
your dealer.
BE SURE to replace the fuse only with an identical
approved type, as originally fitted.
If nonetheless the mains plug is cut off ensure to remove the
fuse and dispose of the plug immediately, to avoid a possible
shock hazard by inadvertent connection to the mains supply.
If this product is not supplied fitted with a mains plug then
follow the instructions given below:
IMPORTANT:
DO NOT make any connection to the terminal which is
marked with the letter E or by the safety earth symbol or
coloured green or green-and-yellow.
The wires in the mains lead on this product are coloured in
accordance with the following code:
Blue:
Neutral
Brown:
Live
As these colours may not correspond with the coloured
markings identifying the terminals in your plug proceed as
follows:
The wire which is coloured blue must be connected to the
terminal which is marked with the letter N or coloured black.
The wire which is coloured brown must be connected to the
terminal which is marked with the letter L or coloured red.
IF IN DOUBT - CONSULT A COMPETENT ELECTRICIAN.
CAUTION
·Do not block the ventilation openings or holes.
(If the ventilation openings or holes are blocked by a
newspaper or cloth, etc., the heat may not be able to get
out.)
·Do not place any naked flame sources, such as lighted
candles, on the apparatus.
·When discarding batteries, environmental problems must
be considered and local rules or laws governing the
disposal of these batteries must be followed strictly.
·Do not expose this apparatus to rain, moisture, dripping or
splashing and that no objects filled with liquids, such as
vases, shall be placed on the apparatus.
UX-G45[B].BOOK Page 1 Friday, February 10, 2006 1:03 PM
G-2
IMPORTANT FOR LASER PRODUCTS
1. CLASS 1 LASER PRODUCT
2. CAUTION: Do not open the top cover. There are no user serviceable parts inside the
unit; leave all servicing to qualified service personnel.
3. CAUTION: VISIBLE AND / OR INVISIBLE CLASS 1M LASER RADIATION WHEN
OPEN. DO NOT STARE INTO BEAM OR VIEW DIRECTLY WITH OPTICAL
INSTRUMENTS.
4. REPRODUCTION OF LABEL: CAUTION LABEL, PLACED INSIDE THE UNIT.
Caution: Proper Ventilation
To avoid risk of electric shock and fire, and to prevent damage, locate the apparatus as follows:
1. Front: No obstructions and open spacing.
2. Sides/ Top/ Back: No obstructions should be placed in the areas shown by the dimensions below.
3. Bottom: Place on the level surface. Maintain an adequate air path for ventilation by placing on a stand with a height of 10 cm
or more.
About the cooling fan
A cooling fan is mounted on the rear panel of the unit to prevent abnormal temperature inside the unit, thus assuring normal
operation of the unit. The cooling fan automatically starts rotating to intake external cool air when the volume is increased up
to more than a certain level.
10 cm
15 cm
1 cm
15 cm
15 cm
1 cm
15 cm
15 cm
Front
Side
SP-UXG45
CA-UXG45
SP-UXG45
CA-UXG45
UX-G45[B].BOOK Page 2 Friday, February 10, 2006 1:03 PM
G-3
SAFETY INSTRUCTIONS
"SOME DOS AND DON'TS ON THE SAFE USE OF EQUIPMENT"
This equipment has been designed and manufactured to meet international safety standards but, like any
electrical equipment, care must be taken if you are to obtain the best results and safety is to be assured.
Do read the operating instructions before you attempt to use the equipment.
Do ensure that all electrical connections (including the mains plug, extension leads and interconnections between
pieces of equipment) are properly made and in accordance with the manufacturer's instructions. Switch off and
withdraw the mains plug when making or changing connections.
Do consult your dealer if you are ever in doubt about the installation, operation or safety of your equipment.
Do be careful with glass panels or doors on equipment.
DON'T continue to operate the equipment if you are in any doubt about it working normally, or if it is damaged in
any way--switch off, withdraw the mains plug and consult your dealer.
DON'T remove any fixed cover as this may expose dangerous voltages.
DON'T leave equipment switched on when it is unattended unless it is specifically stated that it is designed for
unattended operation or has a standby mode.
Switch off using the switch on the equipment and make sure that your family know how to do this.
Special arrangements may need to be made for infirm or handicapped people.
DON'T use equipment such as personal stereos or radios so that you are distracted from the requirements of
traffic safety. It is illegal to watch television whilst driving.
DON'T listen to headphones at high volume as such use can permanently damage your hearing.
DON'T obstruct the ventilation of the equipment, for example with curtains or soft furnishings.
Overheating will cause damage and shorten the life of the equipment.
DON'T use makeshift stands and NEVER fix legs with wood screws--to ensure complete safety always fit the
manufacturer's approved stand or legs with the fixings provided according to the instructions.
DON'T allow electrical equipment to be exposed to rain or moisture.
ABOVE ALL
NEVER let anyone, especially children, push anything into holes, slots or any other opening in the case
--this could result in a fatal electrical shock.;
NEVER guess or take chances with electrical equipment of any kind--it is better to be safe than sorry!
UX-G45[B].BOOK Page 3 Friday, February 10, 2006 1:03 PM
1
Contents
Introduction .................................................... 2
Precautions...................................................................... 2
How to Read This Manual.............................................. 3
Getting Started ............................................... 4
Step 1: Unpack................................................................ 4
Step 2: Prepare the Remote Control ............................... 4
Step 3: Hook Up ............................................................. 5
Before Operating the System ........................ 8
Daily Operations--Playback ......................... 9
Listening to the Radio................................................... 10
Playing Back a Disc...................................................... 11
Playing Back from the USB Memory or
Digital Audio Player ................................................. 11
Playing Back Other Equipment .................................... 13
Quick Portable Link (QP Link) .................................... 13
Daily Operations--Sound &
Other Adjustments ................................... 14
Adjusting the Volume................................................... 14
Adjusting the Sound ..................................................... 14
Changing the Display Brightness--DIMMER............. 15
Setting the Clock .......................................................... 15
Turning Off the Power Automatically.......................... 16
Advanced Radio Operations ....................... 17
Receiving FM Stations with Radio Data System ......... 17
Searching for a Program by PTY Codes....................... 17
Switching Temporarily to a Program of
Your Choice Automatically ...................................... 18
Advanced Disc/USB Memory/
DAP Operations ........................................ 19
Programming the Playing Order--Program Play......... 19
Playing at Random--Random Play .............................. 20
Playing Repeatedly--Repeat Play................................ 21
Prohibiting Disc Ejection--Child Lock ....................... 21
Timer Operations ......................................... 22
Setting the Timer .......................................................... 22
Additional Information ............................... 24
Learning More about This System ............................... 24
Troubleshooting............................................................ 25
Maintenance.................................................................. 26
Specifications................................................................ 26
Parts Index .................................................................... 27
UX-G45[B].BOOK Page 1 Thursday, March 2, 2006 4:26 AM