Operation Guide 3304/3306/4300
1
MA0505-EA
Display Illumination Precautions
The light that illuminates the face uses two LEDs (light-emitting diode) and a light guide
panel that cause the display to glow for easy reading in the dark. The face remains
illuminated as long as you keep L depressed, and for about three seconds after you
release L .
· The illumination provided by the light may be hard to see when viewed under direct
sunlight.
· Frequent use of the light shortens the battery life.
I Avoid setting the date between 8:00 p.m. and 1:00 a.m.
(the date display may not change in the following day).
I For watch with the elapsed time bezel
Rotate the elapsed time bezel to align the
mark with the
minute hand.
After certain amount of time elapsed, read the graduation on the
elapsed time bezel which the minute hand points to.
The elapsed time is indicated.
· Some water resistant models are equipped with a screw lock
crown.
· With such models, you must unscrew the crown in the direction
noted in the illustration to loosen it before you can pull it out.
Do not pull too forcibly on such crowns.
· Also note that such watches are not water resistant while their
crowns are loosened. Be sure to screw the crowns back in as
far as they will go after making any setting.
50
40
30
20
10
Elapsed time bezel
[Modules 3306, 4300]
To Set Time
1) Pull the crown out when the second hand is at
12 o'clock position and the second hand
stops.
2) Turn the hands clockwise and put the watch
four or five minutes forward. Then back them
out.
3) In accordance with a time signal, push the
crown in.
[Module 3304]
To Set Time
1) Pull the crown out to the second click when
the second hand is at 12 o'clock position and
the second hand stops.
2) Turn the hands clockwise and put the watch
four or five minutes forward. Then back them
out.
3) In accordance with a time signal, push the
crown in.
To Set Date
1) Pull the crown out to the first click.
2) Set the date by turning the crown.
3) Push the crown in to the normal position.
Second click
(Setting time)
The configuration of your watch may
differ somewhat from that shown in
the illustration.
30
L (Light button)
Crown (Normal position)
First click
(Setting date)
The configuration of your watch may
differ somewhat from that shown in
the illustration.
L (Light button)
Crown