Module No. 2311
Crown (Normal position)
First click (Setting date)
Second click (Setting time)
To Set Time
Pull the crown out to the second click when the second hand is at 12 o'clock position
and the second hand stops. Set the hands by turning the crown in either direction.
Push the crown in on a time signal.
To Set Date
Pull the crown out to the first click. Set the date by turning the crown. Push the crown
in to the normal position.
· Avoid setting the date between 8:00 pm and 1:00 am.
For watch with the elapsed time bezel
Rotate the elapsed time bezel to align the
mark with
the minute hand.
After certain amount of time elapsed, read the graduation
on the elapsed time bezel which the minute hand points
to. The elapsed time is indicated.
Elapsed time bezel
· Some water resistant models are equipped with a screw
lock crown.
· With such models, you must unscrew the crown in the
direction noted in the illustration to loosen it before you
can pull it out. Do not pull too forcibly on such crowns.
· Also note that such watches are not water resistant while
their crowns are loosened. Be sure to screw the crowns
back in as far as they will go after making any setting.