Operation Guide 4307
1
MA0503-EA
To set the day
1. Pull the crown out to the first click.
2. Set the day by rotating the crown towards you.
3. Push the crown back in to the normal position.
· Avoid changing the date setting while the current time is between 9:00 p.m. and
1:00 a.m.
Using the Stopwatch
The stopwatch lets you measure elapsed time up to 59 minutes, 59.99 seconds.
To measure elapsed time (First 60 seconds)
1. Press A to start the stopwatch.
2. Press A to stop the stopwatch.
· You can resume the measurement operation by pressing A again.
3. Check the elapsed time.
· The example below shows an elapsed time of 44.30 seconds.
· Press B to reset the stopwatch.
This will enter the Timekeeping Mode.
To measure elapsed time (After the first 60 seconds)
1. Press A to start the stopwatch.
· During elapsed time measurement, the stopwatch 1/100 second hand
automatically rotates for the final second of each minute.
2. Press A to stop the stopwatch.
· You can resume the measurement operation by pressing A again.
3. Press the A button, and the stopwatch 1/100 second hand will move to the
1/100 second count.
· If the elapsed time operation was stopped during the final second of each
minute, the stopwatch 1/100 second hand will already be pointing at the
1/100 second count. Do not press the A button at this time, because doing so
will restart the elapsed time operation.
4. Check the elapsed time.
· The example below shows an elapsed time of two minutes, 44.30 seconds.
· Press B to reset the stopwatch.
This will enter the Timekeeping Mode.
Notes:
· Do not try to perform stopwatch operations while the crown is pulled out either to
the first or second click. If you try to press a button, you might accidentally cause
the crown to rotate and change the current time or day setting.
· If the starting positions of the stopwatch second hand and 1/100 second hand
become misaligned, use the following procedures to adjust the positions of the
hands so they point to 12 o'clock when the stopwatch is reset.
To adjust the positions of the stopwatch hands
1. Press B to reset the stopwatch, and check the alignment of the stopwatch
second hand and 1/100 second hand.
2. Pull out the crown to the second click.
3. Press A to move the stopwatch 1/100 second hand.
4. If the stopwatch minute hand is aligned correctly, proceed to step 5. If the
stopwatch minute hand is also misaligned, press B to move the stopwatch
second hand.
5. After making the adjustments you want, push the crown back in to its normal position.
· Note that pulling the crown out also stops the timekeeping second hand. After
performing the above procedure, you should also adjust the timekeeping setting.
To set the time
1. Pull the crown out to the second
click.
· At this time, the second hand will
move to the 12 o'clock position
and stop there.
2. Set the hands by rotating the
crown. Rotate the crown to move
the hands clockwise. Move the
minute hand four or five minutes
past the time you want to set, and
then back it up to the proper
setting.
· Make sure that you also set the
24-hour hand to the correct hour
of the day.
3. Push the crown back in to the normal
position to restart timekeeping.
I For a watch with an elapsed time bezel
Rotate the elapsed time bezel to align the
mark with the
minute hand.
After certain amount of time elapsed, read the graduation on
the elapsed time bezel which the minute hand points to.
The elapsed time is indicated.
· Some water resistant models are equipped with a screw lock
crown.
· With such models, you must unscrew the crown in the
direction noted in the illustration to loosen it before you can
pull it out. Do not pull too forcibly on such crowns.
· Also note that such watches are not water resistant while
their crowns are loosened. Be sure to screw the crowns
back in as far as they will go after making any setting.
Stopwatch second hand
[44 seconds]
Stopwatch 1/100 second hand
[30]
Stopwatch minute hand
*
This hand rotates and
indicates the second
count during the first
60 seconds.
Stopwatch 1/100 second hand
Stopwatch second hand
Stopwatch minute hand
[2 minutes]
Stopwatch second hand
[44 seconds]
Stopwatch 1/100 second hand
[30]
Minute hand
24-hour hand
Hour hand
First click
(Setting day)
Second click
(Setting time)
Crown
(Normal position)
Day
Second hand
50
40
30
20
10
Elapsed time bezel