dr16
HARD DISK RECORDER
Version 2.10 Addendum
Operator's Manual
WARNING
To prevent fire or shock hazard, do not
expose this appliance to rain or moisture.
970310 Printed in Japan
1997/03/10
DR16 Table of contents
i
Version 2.1
Table of contents
Outline of New Functions ............................................. 1
New functions .................................................................................... 1
Removed function .............................................................................. 1
Extended Disk Format ................................................... 2
Extended format procedure ................................................................. 2
Format type indication ........................................................................ 2
Crossfade recording ...................................................... 3
Digital Audio Sync ........................................................ 4
Setting digital clock sync .................................................................... 4
New Bi-phase Rate ........................................................ 5
Options ......................................................................... 6
GPIO .................................................................................................. 6
TDIF ................................................................................................... 7
ii
DR16 Table of contents
Version 2.1
DR16 Addendum
1
Version 2.1
Outline of New Functions
The following functions have been added to DR16 software version 2.10:
New functions
· Up to 4,000 audio files can be recorded on a disk. (Extended format)
· A recording crossfade setting of 0-80ms is available.
· A more flexible sync setting is available for digital audio input.
· Bi-phase 24fps pull-down I/O is supported.
· An optional interface board IB-808G GPIO is available.
· An optional Ethernet interface board IB-809E is available.
· An optional interface board IB-D8TIF TDIF is available.
Removed function
· The DR16 does not support multi-sync operation using the remote connector. It supports the operation
performed from an MT8, as usual.
Apology: Due to the limitations of the remote connection circuit (such as a decrease in actual
communication speed caused by an increase in data), the multi-sync operation using the
remote connector, especially the sync operation in Record mode, is not thoroughly
supported.