A
OWNER'S RECORD
For your convenience, record the model number and the serial number (you will
find it on the bottom of your set) in the space provided below. Please refer to
them when you contact your Aiwa dealer in case of difficulty.
Model No.
Serial No.
NOTE
FOR USE IN THE U.S.A.
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential
installation.
This equipment generates, uses, and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on circuit different from that to which
the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
CAUTION
Modifications or adjustments to this product, which are not expressly approved
by the manufacturer, may void the user's right or authority to operate this product.
Highlighted letters in the text of this manual correspond to the illustrations.
PRECAUTIONS
To maintain good performance
· Do not use the unit in places which are extremely hot, cold, dusty or humid. In
particular, do not use or keep the unit in following places.
· in a high humidity area such as a bathroom
· near a heater
· in an area exposed to direct sunlight (e.g., inside a parked car, where it can
become extremely hot)
· near sources of strong magnetism, such as televisions, speakers, or magnets
· where there is a lot of movement or vibration, such as on a car dashboard or
an unstable shelf
For safety
· Do not attempt to disassemble the unit. Laser rays from the optical pickup are
dangerous to the eyes.
· Make sure that pins or other foreign object do not get inside the player.
· Take care not to drop the unit or subject it to strong shocks.
· To keep dust from the pickup lens, keep the disc compartment lid closed after
use. Never touch the lens.
· If you hear no sound when playing a disc, DO NOT turn the volume up high
because music could suddenly start at high volume. Turn the volume control
to the lowest level before starting playback and slowly turn it up to the desired
level.
Note on listening with the headphones
· Listen at moderate volumes to avoid hearing damage.
· Do not wear the headphones while driving or cycling. It may create a traffic
hazard.
· You should use extreme caution or temporarily discontinue use in potentially
hazardous situations, such as walking, jogging, etc.
· Wear them properly; L is left, R is right.
Note on condensation
If the unit is suddenly moved from a cold place to a warm one, it may result in
condensation on the pickup lens and malfunction or playback difficulties.
Should this occur, leave the unit for a few hours, then try to playback again.
USING ON DRY CELL BATTERIES
A
Open the battery compartment and insert two size AA (LR6) alkaline
batteries with the
0 and 9 marks correctly aligned.
Battery replacement
OPE/BATT indicator changes from F (green) to M (orange) to E (red) according
to the remaining power of the batteries. Replace the batteries when E (red) lights.
If the unit remains in use after E (red) lights, "Lo-bAtt" appears and operation
stops.
Battery life (using alkaline batteries LR6)
Battery life may vary depending on conditions of use.
If the cover of the battery compartment comes off
B
B
AA (LR6)
× 2
A
d
XP-R207
COMPACT DISC PLAYER
OPERATING INSTRUCTIONS
8A-HC1-941-01
000824AYO-OX
Printed in Hong Kong
c
The setting of the E·A·S·S switch
Battery life
48
Approx. 20 hours
12
Approx. 19 hours
OFF
Approx. 15 hours
hazard.
· You should use extreme caution or temporarily discontinue use in potentially
hazardous situations, such as walking, jogging, etc.
· Wear them properly; L is left, R is right.
Note on condensation
If the unit is suddenly moved from a cold place to a warm one, it may result in
condensation on the pickup lens and malfunction or playback difficulties.
Should this occur, leave the unit for a few hours, then try to playback again.
USING ON DRY CELL BATTERIES
A
Open the battery compartment and insert two size AA (LR6) alkaline
batteries with the
0 and 9 marks correctly aligned.
Battery replacement
OPE/BATT indicator changes from F (green) to M (orange) to E (red) according
to the remaining power of the batteries. Replace the batteries when E (red) lights.
If the unit remains in use after E (red) lights, "Lo-bAtt" appears and operation
stops.
Battery life (using alkaline batteries LR6)
Battery life may vary depending on conditions of use.
If the cover of the battery compartment comes off
B
Note on dry cell batteries
· Make sure that the
0 and 9 marks are correctly aligned.
· Do not mix the different types of batteries, or an old battery with a new one.
· To prevent the risk of electrolyte leakage or explosions, never recharge the
batteries, apply heat to them, or take them apart.
· When not using the batteries, remove them to prevent needless battery wear.
· If liquid leaks from the batteries, wipe thoroughly to remove.
B
The setting of the E·A·S·S switch
Battery life
48
Approx. 20 hours
12
Approx. 19 hours
OFF
Approx. 15 hours
USING ON RECHARGEABLE BATTERIES
C
· Be sure to use size AA Ni-Cd 1.2 V 700 mAh rechargeable batteries, which are
commercially available.
· Be sure to read the instructions of the purchased rechargeable batteries before
use.
· When using on rechargeable batteries for the first time, charge them until the
battery indicator goes out.
· Before charging the batteries, close the disc compartment. You cannot charge
the batteries while it is opened.
1 Insert the rechargeable batteries with the
0 and 9 marks correctly
aligned.
2 Connect the AC adaptor.
1 to DC 5 ~ 6 V jack
2 to a wall outlet
3 Keep
sSTOP/OFF/CHARGE pressed for about 1 second to start charging.
"C-On" appears, and OPE/BATT indicator blinks.
When charging is completed, "C-OFF" flashes a few times, and OPE/BATT
indicator goes out.
After charging, disconnect the AC adaptor.
Time to recharge the batteries
Recharge the batteries when E (red) lights. If the unit remains in use after E
(red) lights, "Lo-bAtt" appears and the current operation stops.
To stop charging
Press
sSTOP/OFF/CHARGE during charging.
ATTENTION:
The product you have purchased can be powered by
nickel cadmium batteries which is recyclable. At the
end of their useful life, under various state and local
laws, it is illegal to dispose of these batteries into your
municipal waste stream.
Please call 1-800-289-2492 for information on how to
recycle these batteries.
USING ON AC HOUSE CURRENT
Connect the supplied AC adaptor in the same way as when recharging the
batteries.
During operation on AC house current, all of OPE/BATT indicators light.
BEFORE PLAYBACK
HOLD switch
D
Release the HOLD switch before playback.
a
When not using the unit, set the HOLD switch to the HOLD position.
b
Accidentally pressed button will not function.
If buttons are pressed when the HOLD switch is set to the HOLD position, "HOLd"
flashes in the display.
Turning on and off
D
Turning the power on
Press
ePLAY/PAUSE. Power is turned on and playback starts.
Note
"Err" appears on the display when you play a disc placed upside-down or a
defective disc.
Turning the power off
If no new operations are done within 30 seconds from the end of last operation,
the power is turned off automatically. (Auto power off function)
· You can turn off the power by pressing
sSTOP/OFF/CHARGE before it is
automatically turned off.
Standby mode
D
When an operation finishes, the unit goes into standby mode until the auto power
off function automatically turns off the power.
To enter standby mode, press
ePLAY/PAUSE to start playback, then press
sSTOP/OFF/CHARGE.
Adjusting the sound
E
Volume
Turn the VOL control to adjust the volume.
DSL
Press DSL repeatedly for more powerful sound and deeper bass.
: Deep bass is emphasized.
: Deep bass is strongly emphasized.
: Normal sound
Signal sound function
You can check the operation by beep sound when you press an operation button.
The signal sound function is not activated when you purchase this unit.
To use the signal sound function, press
ePLAY/PAUSE while pressing PLAY
MODE while in stop mode. The beep sound is heard when you press a button.
To cancel the beep sound, repeat this procedure.
C 12
3
D
E
F 1
23
G
XP-R207 (AU) E Page 1
defective disc.
Turning the power off
If no new operations are done within 30 seconds from the end of last operation,
the power is turned off automatically. (Auto power off function)
· You can turn off the power by pressing
sSTOP/OFF/CHARGE before it is
automatically turned off.
Standby mode
D
When an operation finishes, the unit goes into standby mode until the auto power
off function automatically turns off the power.
To enter standby mode, press
ePLAY/PAUSE to start playback, then press
sSTOP/OFF/CHARGE.
Adjusting the sound
E
Volume
Turn the VOL control to adjust the volume.
DSL
Press DSL repeatedly for more powerful sound and deeper bass.
: Deep bass is emphasized.
: Deep bass is strongly emphasized.
: Normal sound
Signal sound function
You can check the operation by beep sound when you press an operation button.
The signal sound function is not activated when you purchase this unit.
To use the signal sound function, press
ePLAY/PAUSE while pressing PLAY
MODE while in stop mode. The beep sound is heard when you press a button.
To cancel the beep sound, repeat this procedure.
Inserting a disc
F
1 Slide the OPEN switch to open the disc compartment.
2 Place a disc in the center with the label side facing up.
3 Close the disc compartment.
To remove the disc
G
Pick up the disc, holding its edge, while pressing the pivot gently.
Note
· The unit may not play a CD-R/RW disc that is recorded on personal computers
or some kinds of CD-R/RW recorders because of differences in recording
platforms.
· Do not attach any seal or label to either side (the recordable side or the labeled
side) of a CD-R/RW disc. It may cause malfunction.
F 1
23
G
B
PLAYBACK
H
Connect the supplied headphones to the PHONES/LINE OUT jack.
1 Release HOLD.
2 Place a disc.
3 Press
ePLAY/PAUSE.
Playback starts from the first track.
a track number
b elapsed playing time
Basic operation
Display during playback
I
Press ENTER/DISP during playback to change the display as follows.
1 Track display and elapsed playing time (normal display)
V
2 Track display and remaining playing time of the track in play
V
3 Remaining number of tracks and remaining playing time
The time is not displayed in following cases.
· When trying to program tracks beyond No.32.
· When the total remaining time of the programmed tracks is over 100 minutes.
E·A·S·S PLUS (Electronic Anti-Shock System)
J
The E·A·S·S PLUS function reduces skipping or muting of the sound when the
unit is subjected to shocks.
The player keeps about 48 seconds or 12 seconds of playback sound in its
memory.
To keep 48 seconds in the memory, set the E·A·S·S switch to 48.
To keep 12 seconds in the memory, set the E·A·S·S switch to 12.
To cancel the E·A·S·S PLUS function, set the E·A·S·S switch to OFF.
Note
· Before jogging with this unit, allow sufficient time for the memory buffer to fill up
completely (ideally 40 to 48 seconds).
Continuous shock or vibration may cause the sound to be interrupted even if
the E·A·S·S PLUS function is activated. This is normal and not a malfunction.
Should you experience an interruption in sound, stabilize the unit for a few
seconds, then resume your activity.
· When the E·A·S·S switch is slid during playback, the unit will pause for about
2 seconds.
· When you set the E·A·S·S switch to the 12 or OFF position, the quality of the
sound will be better than the case that you set it to the 48 position.
Resume function
K
Set the HOLD switch to RESUME.
appears, and you can start playback from the point where you stopped
playback by pressing
sSTOP/OFF/CHARGE.
When the resume function is on, all-track repeat is selected automatically.
To cancel resume play, set the HOLD switch to OFF.
Note
· Resume play may start at a point about 30 seconds behind or ahead the stopped
point. Resume play may not operate if you stopped at the last 30 seconds of
the final track.
· Resume play will be canceled if you open the disc compartment. If the unit is
turned off, resume play will not be canceled. In this case, be sure to set the
HOLD switch to OFF before changing discs.
Random play
K
Press PLAY MODE while in standby mode to display
.
Tracks on the disc are played in random order.
To cancel random play, press PLAY MODE while in standby mode.
display changes to
.
Note
· You cannot back to previous track by pressing
r during random play.
· You cannot select one-track repeat during random play.
Repeat play
K
Press PLAY MODE during playback to select repeat play as follows.
: one-track repeat
V
: all-track repeat
V
no repeat play (normal play)
PROGRAM PLAY
L
3
J
K
12
H
V
V
To stop
To pause
To search for the beginning of a track
To locate a desired passage
Press
sSTOP/OFF/CHARGE.
Press
ePLAY/PAUSE.
To resume, press it again.
Press
r or t.
Keep
r or t pressed.
Release the button at the start of desired
passage.
I
ENTER/DISP
V
V