CT-FX530M YU
STEREO CAR CASSETTE RECEIVER
RADIO-CASSETTE ESTEREOFONICO PARA AUTOMOVIL
d
OPERATING INSTRUCTIONS
MANUAL DE INSTRUCCIONES
MODE D'EMPLOI
OWNER'S RECORD
For your convenience, record the model number and
serial number (you will find them on the right side of
your set) in the space provided below. Please refer to
them when you contact your AIWA dealer in case of
difficulty.
Model No. CT-FX530M
Serial No.
ENGLISH
ESPAÑOL
FRANÇAIS
c
8A-KT9-901-11
000131BTM-OX
Printed in China
A
tousi-E-2
1 ENGLISH
Welcome
Thank you for your purchasing this AIWA product.
To optimize the performance of this unit, please
read through this manual carefully.
In addition to this operating instructions manual,
be sure to refer to the separate installation and
connections manuals as well.
PRECAUTIONS
· This unit is designed to be operated on a 12-volt
DC negative-ground electrical system only.
· To prevent short-circuiting, disconnect the
negative car battery terminal until the unit has
been mounted and connected completely.
· When replacing the fuse, be sure to use one
whose amperage rating is identical. Use of a
fuse of higher amperage may cause serious
damage to the unit.
· Keep screwdrivers, etc. and other metallic or
magnetic objects away from the playback head.
· When your car was parked in direct sunlight
resulting in a considerable rise in temperature
inside the car, allow the unit to cool off before
operating it.
· Keep the volume at such a level that you can
hear outside warning sounds (horns, sirens,
etc.).
Notes on cassettes
Do NOT expose cassettes to direct sunlight,
extremely high or cold temperature or moisture.
Keep cassettes away from equipment with built-
in magnets to avoid unwanted noise or loss of
sound quality.
Do NOT touch the tape of a cassette, as any dirt
or dust will contaminate the heads.
Be sure to remove any cassette from the unit if
you are not using it.
NOTE
This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable
protection against harmful interference in a
residential installation.
This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and
used in accordance with the instructions, may
cause
harmful
interference
to
radio
communications. However, there is no guarantee
that interference will not occur in a particular
installation. If this equipment does cause harmful
interference to radio or television reception, which
can be determined by turning the equipment off
and on, the user is encouraged to try to correct
the interference by one or more of the following
measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the
equipment and receiver.
-- Connect the equipment into an outlet on
circuit different from that to which the
receiver is connected.
-- Consult the dealer or an experienced radio/
TV technician for help.
CAUTION
Modifications or adjustments to this product, which
are not expressly approved by the manufacturer,
may void the user's right or authority to operate
this product.
tousi-E-3
ENGLISH
ENGLISH
2
TABLE OF CONTENTS
PARTS AND CONTROLS .................................................................................................................. 3
DETACHING AND ATTACHING THE FRONT PANEL ...................................................................... 4
SETTING THE CLOCK ....................................................................................................................... 5
RADIO OPERATION .......................................................................................................................... 5
PRESETTING STATIONS .................................................................................................................. 6
MY INFORMATION SWITCH ............................................................................................................. 8
TAPE PLAYBACK ............................................................................................................................. 10
SOUND ADJUSTMENTS ................................................................................................................. 11
CD CHANGER PLAY ........................................................................................................................ 13
CONNECTING A PORTABLE CD/MD/MP3 PLAYER OR OTHER EQUIPMENT ........................... 14
SETTING THE BEEP TONE ............................................................................................................. 14
SETTING THE CONTRAST CONTROL ........................................................................................... 14
STEERING-WHEEL-MOUNTED REMOTE CONTROL UNIT .......................................................... 15
TROUBLESHOOTING ...................................................................................................................... 18
MAINTENANCE ................................................................................................................................ 19
SPECIFICATIONS ............................................................................................................................ 19
DEMO (Demonstration) mode
The unit has an extra display mode (DEMO mode), which demonstrates the display of the operation
modes of the unit. The unit switches to DEMO mode automatically if you turn the unit on and leave it as
it is for 5 seconds after all the connections have been completed.
To cancel DEMO mode
During DEMO mode, press and hold DISP for more than 2 seconds.
To resume DEMO mode, press and hold DISP again for more than 2 seconds.
tousi-E-4
3 ENGLISH
Display window
PARTS AND CONTROLS
Rear panel
Front panel
Front panel
1 FUNC (function) button
2 PWR (power on/off)/MUTE button
3 Jog Dial
4 TUNE i/t* (forward skip)/FF (fast
forward) button
5 TUNE k/r* (back skip)/REW (rewind)
button
6 Cassette compartment
7 z (eject) button
8 Sensor for the remote control
9 A.ME (Auto Memory)/PS (Preset Scan)
button
0 % (release) button
! LO (local) button
@ SEL (select) button
# Preset station buttons (1 6)
$ DISC M button*
% DISC N button*
^ INT (intro) button*
& REP (repeat) button*
* REP 1 (repeat 1) button*
D (tape direction) button
( RANDOM button*
) AUX IN jack (3.5-mm dia.)
- DISP (display) button
= INFO (My Information) button
Display window
q MY INFO (My Information) indicator
w H-BASS (High BASS) indicator
e DSSA (Drivers Sound Stage Adjustment)
indicator
r Audio level indicator
t CD-CH (CD changer) indicator*
y Main display section
u ST (stereo) indicator
i LO (local) indicator
o MT (mute) indicator
Rear panel
p Antenna jack
[ REAR preout jacks
] FRONT preout jacks
\ Power supply/speaker connector
a Fuse
s CD changer connector
* Usable only when an optional CD changer is
connected.